An Investigation of the Impact of Signal Strength on Wi-Fi Link ...
An Investigation of the Impact of Signal Strength on Wi-Fi Link ...
An Investigation of the Impact of Signal Strength on Wi-Fi Link ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
AP at Positi<strong>on</strong> “R”<br />
<strong>Fi</strong>gure 5.13 shows <str<strong>on</strong>g>the</str<strong>on</strong>g> results <str<strong>on</strong>g>of</str<strong>on</strong>g> distance, RSS and throughput when <str<strong>on</strong>g>the</str<strong>on</strong>g> AP was located<br />
at positi<strong>on</strong> “R”. Even though RSS was same <strong>on</strong> different measurement points,<br />
throughput could be different. For example, measurement point “(H-3.5m)H-F” and<br />
“M” had <str<strong>on</strong>g>the</str<strong>on</strong>g> same RSS (-71 dBm, refer table B.5). Both measurement points were<br />
located in <str<strong>on</strong>g>the</str<strong>on</strong>g> NLOS from <str<strong>on</strong>g>the</str<strong>on</strong>g> AP. The throughput <str<strong>on</strong>g>of</str<strong>on</strong>g> measurement point “(H-3.5m)H-F”<br />
was 5.662 Mbps, which was lower than measurement point “M” (7.314 Mbps).<br />
However, <str<strong>on</strong>g>the</str<strong>on</strong>g> distance between “(H-3.5m)H-F” and <str<strong>on</strong>g>the</str<strong>on</strong>g> AP was 21.29 meters, while <str<strong>on</strong>g>the</str<strong>on</strong>g><br />
distance between “M” and <str<strong>on</strong>g>the</str<strong>on</strong>g> AP was <strong>on</strong>ly 13.83 meters, thus distance is <strong>on</strong>e <str<strong>on</strong>g>of</str<strong>on</strong>g> <str<strong>on</strong>g>the</str<strong>on</strong>g> key<br />
factors to determine WLAN throughput.<br />
40<br />
20<br />
0<br />
-20<br />
-40<br />
-60<br />
-80<br />
-100<br />
Access Point at positi<strong>on</strong> "R" : Distance/RSSI/Throughput<br />
A B C D E G H F I L M J K N O P Q S<br />
- 73 -<br />
RX Positi<strong>on</strong><br />
<strong>Fi</strong>gure 5.13: Distance/RSSI/Throughput for AP at positi<strong>on</strong> “R”.<br />
RSSI (dBm)<br />
Throughput (Mbps)<br />
Distance (meter)<br />
<strong>Fi</strong>gure 5.14 shows throughput map <str<strong>on</strong>g>of</str<strong>on</strong>g> <str<strong>on</strong>g>the</str<strong>on</strong>g> AP when it was placed at positi<strong>on</strong> “R”. The<br />
average throughput was adequate <strong>on</strong> <str<strong>on</strong>g>the</str<strong>on</strong>g> “right-hand side” <str<strong>on</strong>g>of</str<strong>on</strong>g> <str<strong>on</strong>g>the</str<strong>on</strong>g> <str<strong>on</strong>g>of</str<strong>on</strong>g>fice. The area <str<strong>on</strong>g>of</str<strong>on</strong>g>