An Investigation of the Impact of Signal Strength on Wi-Fi Link ...

More documents

Recommendations

Info

5.4.2 AP Mode With E<strong>the</strong>rnet Connection Figure 5.20 shows <strong>the</strong> results <strong>of</strong> distance, RSS and throughput when TX was located at 2 meters from <strong>the</strong> AP (SSID: Auckland). Figure 5.21 shows results <strong>of</strong> distance, RSS and throughput, when TX was located at 2 meters from <strong>the</strong> AP (SSID: Wellington). 20 10 0 -10 -20 -30 -40 -50 -60 -70 -80 20 10 0 -10 -20 -30 -40 -50 -60 -70 -80 RSSI/Distance/Throughput, AP mode with E<strong>the</strong>rnet Connection N O P Q R S J K Distance (Meter) I RX Position RSSI (dBm) Throughput (Mbps) Figure 5.20: Results for AP mode with E<strong>the</strong>rnet connection TX at BSS1. RSSI/Distance/Throughput, AP mode with E<strong>the</strong>rnet Connection E D C B A G H F I RX Position Figure 5.21: Results for AP mode with E<strong>the</strong>rnet connection TX at BSS2. - 84 - Distance (Meter) RSSI (dBm) Throughput (Mbps)
The average throughput <strong>of</strong> <strong>the</strong> “AP mode” with E<strong>the</strong>rnet connection was 14.347 and 13.749 Mbps (refer tables D.3 and D.4). These results were close to phase 2 measurement results (14.834 Mbps, refer table 5.3). Fur<strong>the</strong>rmore, under same AP configuration, RSS was -43 dBm in <strong>the</strong> preliminary measurement (refer table A.4), which was much better than phase 3 measurement results (-44 dBm ~ -70 dBm). However, <strong>the</strong> throughput <strong>of</strong> preliminary measurement (11.863 Mbps, refer table A.4) was 18% lower than this measurement (14.347 Mbps). This is due to <strong>the</strong> fact that different locations <strong>of</strong> APs and RX, and radio propagation environment lead to inconsistent results. Thus, <strong>the</strong> results revealed that positions <strong>of</strong> APs and RX, and radio propagation environment have important impact on Wi-Fi link throughput. 5.4.3 Comments <strong>An</strong> exhaustive propagation study and phase 3 measurement results are presented. The results showed that two APs can provide much better signal strength and throughput than a single AP in this <strong>of</strong>fice. With two APs configuration, throughput can be quite close to <strong>the</strong> estimated throughput. Thus, two APs are found to be sufficient for this entire floor coverage. With <strong>the</strong> same radio propagation environment and similar RSS value, <strong>the</strong> average throughput <strong>of</strong> “WDS with AP mode” was much lower than “AP mode” with E<strong>the</strong>rnet connection. Therefore, “AP mode” with E<strong>the</strong>rnet connection configuration provides better performance than <strong>the</strong> “WDS with AP mode” configuration. - 85 -
Page 1 and 2:
An Investi
Page 3 and 4:
2.3.5 Signal <stro
Page 5 and 6:
Attestation of Aut
Page 7 and 8:
Abstract Wireless local area networ
Page 9 and 10:
List of Abbreviati
Page 11 and 12:
List of Figures Fi
Page 13 and 14:
List of Tables Tab
Page 15 and 16:
Chapter 1 Introduction There has be
Page 17 and 18:
WLAN performance evaluation and ana
Page 19 and 20:
Chapter 2 Background and Related Wo
Page 21 and 22:
The IEEE 802.11 networks have two o
Page 23 and 24:
The coverage of a
Page 25 and 26:
2.2.1 Physical Layer Figure 2.8 sho
Page 27 and 28:
throughput significantly at higher
Page 29 and 30:
DCF is designed to provide “best-
Page 31 and 32:
Figure 2.11: Backof</strong
Page 33 and 34:
modulation in [37]. According to si
Page 35 and 36:
Figure 2.12: Net throughput <strong
Page 37 and 38:
As highlighted in [46, 47], distanc
Page 39 and 40:
2.3.2 Base Station Placement <stron
Page 41 and 42:
gained an insight that this would m
Page 43 and 44:
proposed to improve WLAN performanc
Page 45 and 46:
specifications of
Page 47 and 48: dynamic and complicated. As argued
Page 49 and 50: In addition, we surveyed and review
Page 51 and 52: 4.1 Performance Metrics A stopwatch
Page 53 and 54: Model: DWL-G132 Specification: Sta
Page 55 and 56: Figure 4.1: WY building layout. - 4
Page 57 and 58: Figure 4.2 shows wireless configura
Page 59 and 60: 4.4.2 Wireless Adapter Configuratio
Page 61 and 62: 4.4.3 AP Operation Mode Two APs (D-
Page 63 and 64: meeting room with different distanc
Page 65 and 66: Scenario 4 In figure 4.12, two APs
Page 67 and 68: “(H-3.5m)F-H” is the</s
Page 69 and 70: Figure 4.16: Phase 2 measurement: A
Page 71 and 72: performed the prop
Page 73 and 74: The receiver sensitivity is an impo
Page 75 and 76: In table 5.1, the
Page 77 and 78: Ethernet connectio
Page 79 and 80: sufficient signal coverage and thro
Page 81 and 82: throughput decreases along with low
Page 83 and 84: In table 5.1, when RSS is larger th
Page 85 and 86: (for example, measurement point “
Page 87 and 88: AP at Position “R” Figure 5.13
Page 89 and 90: The measurement results indicated t
Page 91 and 92: 5.2.2 Throughput An</strong
Page 93 and 94: impact on RSS and throughput. Resul
Page 95 and 96: The throughput of
Page 97: The RSS of “WDS
Page 101 and 102: The average data size of</s
Page 103 and 104: 5.6.1 SOHO Environment Due to <stro
Page 105 and 106: The following notes are needed to b
Page 107 and 108: when APs were placed at positions
Page 109 and 110: Real and accurate results for AP pl
Page 111 and 112: Chapter 7 Summary and Conclusions W
Page 113 and 114: planning. Propagation measurement (
Page 115 and 116: deployment. Many WLANs are deployed
Page 117 and 118: placement in indoor wireless system
Page 119 and 120: Communications, vol. 2, no. 5, pp.
Page 121 and 122: [56] J. K. L. Wong, M. J. Neve, and
Page 123 and 124: eceived signal strength of<
Page 125 and 126: Appendix A Preliminary Experimental
Page 127 and 128: 2. AP Mode Measurement in t
Page 129 and 130: 7. The Ad-Hoc Mode Measurement on <
Page 131 and 132: Appendix B Phase 1 Experimental Res
Page 133 and 134: (P-1.5m)O-P 32.78 -86 193.6 0.453 N
Page 135 and 136: 3. Access Point at Position “E-3M
Page 137 and 138: (C-5m)C-D 21.63 -83 46.8 1.875 NLOS
Page 139 and 140: J 9.00 -44 8.2 10.703 LOS (J-1.5m)J
Page 141 and 142: 7. Access Point at Position “H”
Page 143 and 144: Figure B.2: Throughput map for AP a
Page 145 and 146: 60 40 20 0 -20 -40 -60 -80 -100 Acc
Page 147 and 148: (N-3m)N-O 15.00 -72 15.6 5.626 NLOS
Page 149 and 150:
(C-3m)C-D 14.32 -74 13.6 6.453 NLOS
Page 151 and 152:
Figure B.8: Throughput map for AP a
Page 153 and 154:
60 40 20 0 -20 -40 -60 -80 -100 Acc
Page 155 and 156:
AP at A RX Position Left-Hand Area
Page 157 and 158:
AP at L RX Position Left-Hand Area
Page 159 and 160:
Appendix D Phase 3 Experimental Res
Page 161 and 162:
TX at 2M from E-3M Data File: 153.6
Page 163 and 164:
IEEE 802.11 b/g Access Point DWL-21
Page 165 and 166:
Standards • IEEE 802.11g • IEEE
Page 167 and 168:
1 Maximum wireless signal rate deri
Page 169 and 170:
Wireless 108G Standards • 802.11b
Page 171 and 172:
Wireless 108G Add 802.11g Wireless
Page 173:
2.4GHz Omni-Directional 7dBi Indoor
show all

An Investigation of the Impact of Signal Strength on Wi-Fi Link ...

Create successful ePaper yourself

Delete template?

Save as template?