coMsat Multichannel PRA
coMsat Multichannel PRA
coMsat Multichannel PRA
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Multichannel</strong> <strong>PRA</strong><br />
On the frontside are located:<br />
the LED control indicators of the system<br />
st nd<br />
the jacks for the external synchronization (RJ45 “in” and “out”) (1P<br />
P and 2P<br />
P<br />
from top)<br />
rd<br />
the jack for the PRI-1 connection (RJ-45) (3P<br />
P from top)<br />
(Please notice: You can only use external synchronization or PRI-1)<br />
th<br />
the jack for the PRI-2 connection (RJ-45) (4P<br />
P from top)<br />
the connector for the serial port for firmware update (upper D-SUB 9 “Boot”)<br />
the connector for the serial port for configuration (lower D-SUB 9 “CFG”)<br />
the jack for the Ethernet connection (RJ-45, on CPU board)<br />
On the rearside are located:<br />
the connector for the power supply, 230VAC<br />
the on/off switch<br />
the 1 or 2 RF- (N) connectors for the GSM antennas<br />
The connections and significance of the LED’s are labeled to prevent errors. (see<br />
signaling description in the “Starting up” section” and at the end of this document)<br />
date: page: file:<br />
15.02.2008 10:32 15 Manual <strong>coMsat</strong> <strong>Multichannel</strong> <strong>PRA</strong> 3-3 eng.doc<br />
Note Protection Mark according to DIN 34!
Change language