coMsat Multichannel PRA

Multichannel PRA
First select the Extension transfer mode for outgoing calls:
• Deactivated: Only the Called party number will be sent
• Append extension: The called party number and the extension will be
concatenated. Prefix and Separator will be added as given in the respective
fields.
• Append extension and its length: The same as before, but the length of the
extension is added as a single digit at the end of the string (after the extension)
The fields Prefix and Separator are used in the modes “Append extension” and
“Append ext. and its length”.
Note: These fields may also be empty.
The maximum size of the resulting number is limited by the Max. GSM No. Size
parameter. If the resulting length would be greater only the called number will be
send.
Figure 56: VPN Support
Example: The extension 1234 calls the number 05498765. According to the settings
in the above screen copy the four displayed channels 1 to 4 (left to right) will dial the
following number:
Channel 1: 05498765
Channel 2: 05498765#1234
Channel 3: 9999054987651234
Channel 4: 0549876512344
6.5.2.2 Incoming Calls
On incoming calls the number of the caller (CLI) can be interpreted as a composition
of the original CLI of the caller and the called extension, where one part is of a
constant length, or the to parts are separated by a special character (e.g. #) :
First select the Extension transfer mode for incoming calls:
• Deactivated/Separator only: If you gave a separator character and this character
is in the CLI, the CLI will be interpreted as CLI and extension, separated by the
respective character. Otherwise the number is taken as CLI.
• Constant CLI length: The first n digits are interpreted as the CLI, the rest as
extension, where n is given in Length of the constant part
date: page: file:
15.02.2008 10:32 66 Manual coMsat Multichannel PRA 3-3 eng.doc
Note Protection Mark according to DIN 34!