coMsat Multichannel PRA

Multichannel PRA
6.7.2 GSM module status
Figure 59: GSM module status
For all installed GSM modules the following information’s are shown:
• Group and identification as entered in the channel parameters (for convenience)
• Channel state. You can click to this field to force a channel reset or enter the
PUK, if necessary.
• Call diversion state. To request/change the diversion click to the respective field
• Signal strength (RSSI, should be at least -90 dB, better -80 dB)
• Bit Error Rate (BER, only availabe during an active call)
• Answer seizure rate (ASR) for this channel.
• Average call duration (ACD) for this channel
Note: The number of referenced calls for ASR and ACD can be edited in the general
parameter page. If it is zero also ASR and ACD will be zero.
• The balance (in minutes) for channels defined as using prepaid SIM cards
• Network, Location, and Cell ID of the current network
• IMSI of the installed SIM card
• Alarm status of this channel
• Description of the installed GSM module
6.7.3 Prepaid Balance
To set the balance of channels configured to use prepaid cards go to the Status
menu and select Prepaid Balance.
In the upcoming dialog you see on the right side a list of all channels showing the
IMSI and the current balance. (For non-prepaid cards there is only a '-' in the
Balance-column.)
Select the channels you want to be affected. This can be done in two ways: Either
click to one of the buttons on the left to select/deselect multiple channels or click to
the checkboxes in the second column of the table to select/deselect single channels.
date: page: file:
15.02.2008 10:32 70 Manual coMsat Multichannel PRA 3-3 eng.doc
Note Protection Mark according to DIN 34!