Installation and Operation Manual - Biznine.com

Table 1-2 describes each back module connector.
Table 1-2. Back Module Connector Descriptions
Back Module Label Description
Chapter 1: Introduction
SDI In 1 and SDI In 2 Inputs HD/SD-SDI video for up, down, or
cross-conversion or reclocking; HD/SD-SDI
signals can also be input for reclocking.
SDI DA Out (4) Outputs SD or HD reclocked video output signals;
video from these outputs by-passes the module’s
scalar processor; configurable for either reclocked
or frame sync outputs
SDI Program Out (2) Outputs HD/SD-SDI converted video
Audio Delay / 6 HZ Outputs the output audio delay signal
SDI Program/Monitor
Out (2)
Outputs a program signal for monitoring
purposes; an on-screen display of XHD6801+
control parameters can be enabled on these
outputs
Reference In Inputs a bi-level (NTSC/PAL-B) or tri-level sync
(1080i/1080p) external video reference source
that can be internally terminated using a jumper
(see page 75 for the video standards supported)
GPI In/Out Provides four GPI inputs and two GPI outputs for
automation (these are open collector style inputs
with approximately 10 KΩ pull-ups to +5V that
can use “contact closure-to-ground” switches)
XHD6801+ Installation and Operation Manual 9