Installation and Operation Manual - Biznine.com
Installation and Operation Manual - Biznine.com
Installation and Operation Manual - Biznine.com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 2: <strong>Installation</strong><br />
2. Place a jumper on pins 1 <strong>and</strong> 2 to set the module for Remote<br />
control, or pins 2 <strong>and</strong> 3 to set the module for Local control. See<br />
Figure 2-2.<br />
Figure 2-2. Remote/Local Control Settings<br />
Note<br />
1 2 3 1 2 3<br />
Remote control Local control<br />
You must configure modules for local or remote operation prior to<br />
power-up. To change the configuration, first remove power from the<br />
module, reset the jumper, <strong>and</strong> then reapply power. The white<br />
triangle near the jumper pins on the module indicates pin 1.<br />
See Table 1-1 on page 7 for more information on local/remote control<br />
jumper functionality.<br />
External Reference Termination Jumper<br />
Follow this procedure to set the external Reference Input Termination<br />
jumper:<br />
1. Locate jumper J1 on the module.<br />
(Figure 2-1 on page 14 shows the location of the jumper.)<br />
2. Place a jumper on pins 1 <strong>and</strong> 2 to set the module for 75Ω<br />
Termination, or pins 2 <strong>and</strong> 3 for No Termination (see Figure 2-3).<br />
1 2 3 1 2 3<br />
75Ω Termination<br />
No Termination<br />
Figure 2-3. Genlock Termination Settings<br />
XHD6801+ <strong>Installation</strong> <strong>and</strong> <strong>Operation</strong> <strong>Manual</strong> 15