Installation and Operation Manual - Biznine.com

Aspect Ratio Conversion
Setting a Standard Aspect Ratio
Chapter 3: Configuration and Operation
For the module output, you can select either a standard ARC setting, or
one of 10 of your own customized preset ARC settings. When using the
ARC function, ensure that you select the correct output in Out Aspect
Ratio (Video > Processing > ARC > Out Aspect Ratio).
To select a standard aspect ratio for the output image, select ARC
Preset Up, ARC Preset Cross, ARC Preset Down, or ARC Preset
SD-ARC (found at Video > Processing > ARC). Each of these
parameters corresponds to one of the four conversion modes (up, cross,
down, and SD-ARC.) As the module changes between conversion
modes—based on either an output format change or an input format
change— the corresponding ARC preset will be applied.
The available standard aspect ratios depend upon the operating mode of
the XHD6801+. In other words, for example, an ARC setting that is
visible in upconversion may not be visible in downconversion.
In some modes, Pixel True is offered as an option. There is no actual
scaling performed in Pixel True. Instead, each input pixel is mapped
directly to one output pixel; you can use this preset to transport an SD
picture embedded inside an HD stream.
The following standard ARC options are available:
• Anamorphic
• 4:3 Pillar Box
• 14:9 Pillar Box
• 16:9 Cut
• 4:3->21:9 Ltr
• 16:9 Letter Box
• 14:9 Letter Box
• 4:3 Cut
• 16:9->21:9 Ltr
• PixelTrue
• Preset 1-Preset 10
• AFD
• AFD - ALTR
XHD6801+ Installation and Operation Manual 37