Installation and Operation Manual - Biznine.com
Installation and Operation Manual - Biznine.com
Installation and Operation Manual - Biznine.com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Correcting a Failed Upgrading Procedure<br />
Chapter 2: <strong>Installation</strong><br />
Firmware upgrades may fail in the event of network interruptions,<br />
power failures, or if the wrong upgrade package was transferred to the<br />
module. These problems can be corrected by upgrading the firmware<br />
while the module is in Boot Loader mode. The upgrade won't work<br />
unless you put the module in Boot Loader mode.<br />
Note<br />
If you have not already downloaded the most recent appropriate<br />
upgrade package from our website or from your CD-ROM, do so<br />
now.<br />
Putting the Module in Boot Loader Mode<br />
Follow these steps to put your the module in Boot Loader mode:<br />
1. Remove the affected module from the 6800+ frame.<br />
Hex switch (mode<br />
select rotary switch)<br />
Navigation toggle<br />
switch<br />
Figure 2-7. Buttons on a Typical Card Edge<br />
2. Set the hex switch to F.<br />
3. While pressing the Navigation toggle switch down, reinsert the<br />
module into the frame.<br />
If your device is listed in the Discovery or Network folder, you can<br />
continue the firmware upgrade as described in “Upgrading the<br />
Firmware” begining with step 3 page 18. If not, you must manually add<br />
the device to the Discovery or Network folder. To do this, see the next<br />
section.<br />
XHD6801+ <strong>Installation</strong> <strong>and</strong> <strong>Operation</strong> <strong>Manual</strong> 21
Change language