Piaggio Fly 4T servicemanual - Scootergrisen
Piaggio Fly 4T servicemanual - Scootergrisen
Piaggio Fly 4T servicemanual - Scootergrisen
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MSS <strong>Fly</strong> 50 <strong>4T</strong> Chassis<br />
QUESTA SEZIONE È IN LAVORAZIONE<br />
Removing the ignition key-switch when on *off*<br />
• Remove the shield back plate<br />
• Push the lock body until the stop spring does not<br />
show grooves.<br />
• Keep the lock body blocked with a screwdriver<br />
and remove the spring with a pair of pliers.<br />
• Take out the lock block.<br />
Removing the ignition key-switch when on *lock*<br />
Remove the shield.<br />
- Remove the switch of the key switch.<br />
- Make a hole on the block using a drill as shown<br />
in the figure.<br />
- Insert the wheel cylinder with the key and with the<br />
anchoring tab facing down halfway on the lock<br />
body taking care that the insertion phase of the key<br />
is oriented matching "ON" (the only position that<br />
enables the cylinder to get into the lock body); now<br />
turn the key leftwards to "OFF" and at the same<br />
time press until the cylinder is completely in.<br />
Footrest<br />
- Remove the side fairings<br />
- Remove the shield back plate<br />
- Remove the 6 screws shown in the photograph<br />
CHAS - 143