Single Reduction & Single Reduction with Differential Lock - Spicer
Single Reduction & Single Reduction with Differential Lock - Spicer
Single Reduction & Single Reduction with Differential Lock - Spicer
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Disassemble and Overhaul Drive Pinion<br />
The following procedures cover both forward and rear differential<br />
drive carrier disassembly.<br />
Rear Axle Pinion Yoke<br />
1. Remove yoke.<br />
If pinion nut was not loosened during earlier disassembly,<br />
clamp assembly in vise jaws, use brass pads to prevent<br />
damage.<br />
15<br />
2. Loosen and remove pinion nut and flat washer.<br />
Remove yoke from pinion using an appropriate tool.<br />
Forward and Rear Axle Pinion Bearing Cage<br />
3. Press pinion out of bearing cage and bearing cone.<br />
1 - Press Ram<br />
CAUTION<br />
Rear Axle Pinion Oil Seal and Outer Bearing Cone<br />
1<br />
4. Remove oil seal and bearing cone from cage. Discard<br />
oil seal. Remove bearing cups <strong>with</strong> suitable<br />
puller.<br />
Pinion Assembly<br />
5. Remove bearing spacer from pinion.<br />
6. Remove pilot bearing from pinion using a split-type<br />
puller. Use two procedure steps to remove each<br />
bearing.<br />
a. Mount puller vertically to separate the bearing. This<br />
action will force puller halves under bearing and start<br />
moving bearing off pinion.<br />
b. Mount puller horizontally to press pinion out of bearing.<br />
7. Remove inner bearing cone from pinion using a<br />
split-type puller. Use two procedure steps to remove<br />
each bearing.