Hand tools catalogue - Unior

2209
Alternator combination socket
This two-part tool for the alternator allows the easy dismounting
and mounting of the alternator pulley for the purposes of pulley
replacement or alternator repair. The alternator is blocked by
means of a 10 mm XZN multispline insert; simultaneously, the
pulley retaining screw on the shaft is released/tightened. The tool
is available as a 1/2" socket key with a XZN – M10 bit and as a 1/2"
socket key with a TX50 bit.
P8
D L1 L2
620225 M 10 23.8 113 75 178
620948 TX 50 23.8 113 75 176
200/2
Starter and block wrench
material: chrome vanadium
surface finish: chrome plated according to EN12540
drop forged, entirely hardened and tempered
P10
L B1 B2 A1 A2
600671 11 x 13 150 16.5 19 7 8.5 54
600672 13 x 17 185 19.2 24.2 8.7 10.3 99
600673 14 x 17 185 20.5 24.2 8.7 10.3 104
600674 15 x 16 185 21.6 23.6 8.7 10.3 104
600675 15 x 17 185 21.6 24.2 8.7 10.3 101
600676 19 x 22 230 27.2 31.8 10 11.5 178
D
L1
L2
200/2CB
Set of starter and block wrenches in carton box
G6
600677 200/2CB 11 - 22 / 5 605
2211
SAC Clutch tool set
200/2 (11 x 13, 13 x 17, 14 x 17, 15 x 16, 19 x 22)
material: special tool steel
entirely hardened and tempered
This SAC clutch tool set can be used to quickly and professionally
dismantle and install SAC clutches. Usually, SAC clutches have 3 spokes,
however some vehicles use 4-spoked versions (e.g. Mercedes A since
2004). Suitable for almost all SAC clutches (3- and 4-spoked), e.g. VW-
Audi, BMW, Mercedes, Volvo, Opel, Renault, etc.
Advantages:
1. pre-tightening of the thrust plate during dismounting and installing
(important for preventing strain on the clutch),
2. centering the clutch plate in the direction towards the guide bearing
or towards the thrust plate,
3. withdrawing the adjusting ring with the withdrawal tools.
Dimension of box: 393 x 331 x 95
P8
A B D H
620233 305 268 322 267 7400
Tools for engine
14
333