Hand tools catalogue - Unior

1625/2
Tool for removing bottom bracket bearing BB30
This tool is designed to remove the non-threaded bottom bracket
bearings of the BB30 bottom bracket system. The removal tool will
drive bearings from the BB30 bottom bracket shell.
A B C D
621660$ 60 54 17 35 19 346
1625/2BB90
Tool for removing bottom bracket BB90
This tool is designed to remove the non-threaded bottom bracket bearings
and cups of the BB90 bottom bracket system. It also supports other press fit
standards with 24mm spindle, such as BB86, BB92, SRAM Press Fit GXP. The
removal tool will pull the bearings & cup from the frame.
623085$ 283
1626/2
Campagnolo and Fulcrum Ultra Torque bearing
removal and installation set
Designed and built to install and remove the pressed bearing used on
Campagnolo® and Fulcrum® Ultra-Torque cranks.
The bearing puller’s forged arms and tapered edges securely pinch under
the bearing while the heavy-duty plunger system “pulls” the bearing.
The installation tool precisely fits both the crank spindle and the press fit
bearing to ensure proper installation. Just tap the bearing into place using
the tool and a hammer.
L D D
621661$ 75 40 75 500
1659/2
Freewheel remover, 1/8"
material: special tool steel, hardened and tempered
surface finish: chrome plated according to EN12540
The freewheel remover is designed for removal of single speed
freewheels, which are broader than multi speed freewheels. The chain
fits precisely to the freewheel teeth and thus enables effective work
without slippage or damage to the sprockets. An added retaining
spring is a special feature distinguishing this tool from similar products.
L C
619589 350 1/2" x 1/8" 357
Tools for drive
15
351