Programming Reference Manual - Public Support Login - Unisys

Error Messages
2176 The name change could not be completed because a file with the requested
qualifier and file name already exists.
Symbolic Name: fp_err_new_name_exists
2177 The name change could not be completed because one or more files of the
F-cycle series are either unloaded or are on a symbiont queue.
Symbolic Name: fp_err_unloaded_or_on_queue
2178 The name change could not be completed for this removable disk file because
it resides on or spans a pack that is in the DN,PACK state.
Symbolic Name: fp_err_removable_pack_down
2181 PCFP did not make the requested change, because fewer F-cycles would be
retained than currently exist, and the function packet indicated that no
currently-existing F-cycles are to be deleted.
Symbolic Name: fp_err_too_many_f_cycles
2182 PCFP did not make the requested change, because the change requires
deletion of F-cycle +0 without eliminating the entire F-cycle series.
Symbolic Name: fp_err_f_cycle_conflict
PCFP issues this error if:
• The F-cycle series contains a file that is to-be-cataloged with an absolute
F-cycle number above that of F-cycle +0 of the series
• PCFP needs to delete F-cycle +0 in order to perform the change
The file to-be-cataloged can be assigned either by your run or by another run.
PCFP also issues this error if:
• The file identifier you specified contains an internal file name
• The internal file name is attached to a specific F-cycle of the F-cycle series
• PCFP needs to delete this F-cycle in order to perform the change
For this function, you must not specify an internal file name attached to a
specific F-cycle.
2183 PCFP did not make the requested change, because the change requires the
deletion of a file that is currently on a symbiont queue. The absolute F-cycle of
the file on the symbiont queue is .
Symbolic Name: fp_err_f_cycle_symmed
7830 9796–013 A–27