HS-105P, PE. SA AutoCam™ Pan & Tilt Head - Vinten Radamec
HS-105P, PE. SA AutoCam™ Pan & Tilt Head - Vinten Radamec
HS-105P, PE. SA AutoCam™ Pan & Tilt Head - Vinten Radamec
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>HS</strong>-<strong>105P</strong> Installation<br />
4. Use a 7/64” hex key to loosen the locking screw in the upper cam. Rotate<br />
the cam on the shaft until it is just counter-clockwise of the upper switch<br />
actuator as shown below. Tighten the locking screw.<br />
Position Upper Cam Just CCW<br />
Of Upper Switch Actuator<br />
5. Manually pan the head in a clockwise direction until you reach the desired<br />
limit position (the pan limit cams will rotate counter-clockwise).<br />
6. Use a 7/64” hex key to loosen the locking screw in the lower cam. Rotate<br />
the cam on the shaft until it is just to the clockwise side of the lower switch<br />
actuator as shown below. Tighten the locking screw.<br />
Position Lower Cam Just CW<br />
Of Lower Switch Actuator<br />
7. Replace the tilt motor cover and tighten the 7 screws with a 3/32” hex key.<br />
User Manual 3-15