Eaton E Series DX Product Manual - Fusion Power System

More documents

Recommendations

Info

① AC: This light and inverter light will turn "green" when UPS is powered by Rectifier Input; ② Inverter: This light will turn "green" when UPS load is through the inverter; ③ Battery: This light will turn "yellow" when UPS is powered by batteries; ④ Bypass: This light will turn "green" when UPS load is powered by Bypass Input; ⑤ Fault: If the UPS worked under fault condition,this light would turn on and stay “red” with continuous warning tone being given off in case of UPS abnormal function;or flash “red” with intermittent warning tone being given off. ⑥ LCD: Display UPS commands. ⑦ :Confirm/Enter; press this button to select a menu or confirm an operation. ⑧ :PageDown; press this button to switch to next screen display under the same menu. ⑨ :PageUp; press this button to return to next screen display under the same menu. ⑩ Esc: Escape; press this button to return to previous menu or cancel a certain operation. Remark: Refer to Chapter 12 for detailed information of LED in accordance with UPS condition. 2.4 Exterior view Exterior figure of Eaton E Series DX 20KVA UPS 6 LCD panel Button LED indicator light PARALLEL Intelligent slot Extended slot Front view Rear view SERVICE AS400 EPO RS485 RS232 Fan
Front view(door open) Exterior figure of Eaton E Series DX 30KVA,40KVA UPS LCD panel Button LED indicator light PARALLEL Intelligent slot Extended slot CHGR FAN Maintenance Bypass Switch Neutral Switch Bypass Input Switch Rectifier Input Switch Front view Rear view SERVICE AS400 EPO RS485 RS232 Fan 7
Page 2 and 3: ©2008 Eaton Corporation All Rights
Page 4 and 5: 5. 6. 7. 8. 9. Electrical installat
Page 6 and 7: 1.3 CE marking The product has the
Page 8 and 9: 2 Introduction The product describe
Page 12 and 13: 8 Front view(door open) CHGR FAN Ma
Page 14 and 15: 3.4 Characteristics 3.5 AC input 10
Page 16 and 17: 4 Mechanical installation The UPS a
Page 18 and 19: 4.3 Planning before installation Th
Page 20 and 21: The switching sequence for circuit
Page 22 and 23: 1)Switch-off picture 2)If it is in
Page 24 and 25: Then the UPS turn to bypass mode. 4
Page 26 and 27: 5 Electrical installation 5.1 Elect
Page 28 and 29: 2.If UPS rectifier input and bypass
Page 30 and 31: Routing of communication cables or
Page 32 and 33: 28 Notice! The most common battery
Page 34 and 35: Recharging batteries Exchanging bat
Page 36 and 37: RS232 port RS485 port 32
Page 38 and 39: 7 User operations 7.1 Single machin
Page 40 and 41: 5)Press ▼ again to obtain the bel
Page 42 and 43: 3)Select “Yes, Confirm” to swit
Page 44 and 45: 5)Select “Yes, Confirm” to swit
Page 46 and 47: 9. Procedures of DC switch-on: 42 A
Page 48 and 49: Single machine wire connection draw
Page 50 and 51: 8.1 Regular service/intervals The U
Page 52 and 53: 48 Note! Parrallel wires should be
Page 54 and 55: 11 Warranty The product is warrante
Page 56: Should any display or warning messa

Eaton E Series DX Product Manual - Fusion Power System

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?