Eaton E Series DX Product Manual - Fusion Power System

More documents

Recommendations

Info

28 Notice! The most common battery type used in UPS installations is the valve regulated battery. Valve regulated cells are not sealed. The amount of gas given off is less than for flooded cells, but when planning the battery installation, allowance must be made for adequate ventilation and heat dissipation. Valve-regulated cells are not completely maintenace- free. They must be kept clean and their connections checked periodically to ensure they are tight, and that there is no evidence of corrosion. It is inevitable that the batteries will lose charge during transportation and storage; before attempting to carry out an autonomy test, ensure that the batteries are fully charged as this may take several hours. Cell performance typically improves after a few discharge/recharge cycles. Notice! The requirements of the EC directives are satisfied when battery cabinet are used with original accessories. If alternative batteries are used, you must ensure that the appli- cable EC directives are met and declare conformity. The battery cabinet is preferably installed to the left of the UPS. Connect the battery cabinet as follows: Check the battery fuses are not inserted and/or any external battery switch is open. Connect PE first. Connect the battery cabinet(s) with cables sized according to cable cross setion and protective device specification to terminals + (positive pole) ,- (negative pole) and Neutral pole. Refer to instruction provided with the battery cabinet or by vendor. Warning! ENSURE CORRECT POLARITY!
5.5 Connections between battery cabinet and UPS Make sure the Protective Earthing (PE) connected first. 5.6 Handling the batteries Warning! External Battery Cabinet Connections Batteries are a potential source of danger due to their electrical charge and chemical composition. Therefore observe the battery handling instructions of the manufacturer. These usually can be found in the material which accompanies the shipment. 29
Page 2 and 3: ©2008 Eaton Corporation All Rights
Page 4 and 5: 5. 6. 7. 8. 9. Electrical installat
Page 6 and 7: 1.3 CE marking The product has the
Page 8 and 9: 2 Introduction The product describe
Page 10 and 11: ① AC: This light and inverter lig
Page 12 and 13: 8 Front view(door open) CHGR FAN Ma
Page 14 and 15: 3.4 Characteristics 3.5 AC input 10
Page 16 and 17: 4 Mechanical installation The UPS a
Page 18 and 19: 4.3 Planning before installation Th
Page 20 and 21: The switching sequence for circuit
Page 22 and 23: 1)Switch-off picture 2)If it is in
Page 24 and 25: Then the UPS turn to bypass mode. 4
Page 26 and 27: 5 Electrical installation 5.1 Elect
Page 28 and 29: 2.If UPS rectifier input and bypass
Page 30 and 31: Routing of communication cables or
Page 34 and 35: Recharging batteries Exchanging bat
Page 36 and 37: RS232 port RS485 port 32
Page 38 and 39: 7 User operations 7.1 Single machin
Page 40 and 41: 5)Press ▼ again to obtain the bel
Page 42 and 43: 3)Select “Yes, Confirm” to swit
Page 44 and 45: 5)Select “Yes, Confirm” to swit
Page 46 and 47: 9. Procedures of DC switch-on: 42 A
Page 48 and 49: Single machine wire connection draw
Page 50 and 51: 8.1 Regular service/intervals The U
Page 52 and 53: 48 Note! Parrallel wires should be
Page 54 and 55: 11 Warranty The product is warrante
Page 56: Should any display or warning messa

Eaton E Series DX Product Manual - Fusion Power System

Create successful ePaper yourself

Delete template?

Save as template?