Eaton E Series DX Product Manual - Fusion Power System

More documents

Recommendations

Info

5)Select “Yes, Confirm” to switch off 6)Normal Switch-off the machine 40 Note! If you intend to switch off only one set of UPS among the parallel machine system, select “single machine switch-off”; if switch-off is intended for the entire parallel machine system, select “parallel machine switch-off”. 6. Help 1)Help picture 2)Press ENTER on help picture
7. Configuration (press ESC to exit the above picture) You are able to access Setting picture by using user combination (default: 1234, subject to personal modification) so as to set the following programs. 1)Action display (bypass power supply) 2) Press ▼ 3)Enter respective password 4)Select action item 8. The <strong>Series</strong> is capable of DC start-up without AC input, panel display being similar to switch-on picture with AC supply. DC switch-on and off are available by following instruc- tions appearing in the pictures. 41
Page 2 and 3: ©2008 Eaton Corporation All Rights
Page 4 and 5: 5. 6. 7. 8. 9. Electrical installat
Page 6 and 7: 1.3 CE marking The product has the
Page 8 and 9: 2 Introduction The product describe
Page 10 and 11: ① AC: This light and inverter lig
Page 12 and 13: 8 Front view(door open) CHGR FAN Ma
Page 14 and 15: 3.4 Characteristics 3.5 AC input 10
Page 16 and 17: 4 Mechanical installation The UPS a
Page 18 and 19: 4.3 Planning before installation Th
Page 20 and 21: The switching sequence for circuit
Page 22 and 23: 1)Switch-off picture 2)If it is in
Page 24 and 25: Then the UPS turn to bypass mode. 4
Page 26 and 27: 5 Electrical installation 5.1 Elect
Page 28 and 29: 2.If UPS rectifier input and bypass
Page 30 and 31: Routing of communication cables or
Page 32 and 33: 28 Notice! The most common battery
Page 34 and 35: Recharging batteries Exchanging bat
Page 36 and 37: RS232 port RS485 port 32
Page 38 and 39: 7 User operations 7.1 Single machin
Page 40 and 41: 5)Press ▼ again to obtain the bel
Page 42 and 43: 3)Select “Yes, Confirm” to swit
Page 46 and 47: 9. Procedures of DC switch-on: 42 A
Page 48 and 49: Single machine wire connection draw
Page 50 and 51: 8.1 Regular service/intervals The U
Page 52 and 53: 48 Note! Parrallel wires should be
Page 54 and 55: 11 Warranty The product is warrante
Page 56: Should any display or warning messa

Eaton E Series DX Product Manual - Fusion Power System

Create successful ePaper yourself

Delete template?

Save as template?