Eaton E Series DX Product Manual - Fusion Power System

More documents

Recommendations

Info

48 Note! Parrallel wires should be connected as a loop.
10 Recycling the used UPS or battery Before scrapping UPS or its battery cabinet, the battery bank must be removed. Local requirements must be followed in battery recycling or discard. The removal of batteries is allowed only by authorised service personnel due to high energy and voltage. Do not discard waste electrical or electronic equipment in the trash. For proper disposal, contact your local collecting/recycling/reuse or hazardous waste center and follow the local legislation. These symbols indicate on a product: You can find out which recycling firm is responsible for your neighbourhood by contacting your local authority. Batteries must not be put in the domestic refuse either! All consumers have a statutory duty to take all batteries to a collection point in their munici- pality/district or to a retail store so that they can be disposed of in an environmentally-friendly way,regardless of whether they contain toxic substances. All batteries should be fully discharged before they are returned for disposal. PROTECTION OF THE ENVIRONMENT/DISPOSAL OF THE EQUIPMENT. Do not on any account put your old equipment out with the domestic refuse. For the sake of the environment,please use your local authority’s collection point set to return and recycle old electric and electronic equipment. 49
Page 2 and 3: ©2008 Eaton Corporation All Rights
Page 4 and 5: 5. 6. 7. 8. 9. Electrical installat
Page 6 and 7: 1.3 CE marking The product has the
Page 8 and 9: 2 Introduction The product describe
Page 10 and 11: ① AC: This light and inverter lig
Page 12 and 13: 8 Front view(door open) CHGR FAN Ma
Page 14 and 15: 3.4 Characteristics 3.5 AC input 10
Page 16 and 17: 4 Mechanical installation The UPS a
Page 18 and 19: 4.3 Planning before installation Th
Page 20 and 21: The switching sequence for circuit
Page 22 and 23: 1)Switch-off picture 2)If it is in
Page 24 and 25: Then the UPS turn to bypass mode. 4
Page 26 and 27: 5 Electrical installation 5.1 Elect
Page 28 and 29: 2.If UPS rectifier input and bypass
Page 30 and 31: Routing of communication cables or
Page 32 and 33: 28 Notice! The most common battery
Page 34 and 35: Recharging batteries Exchanging bat
Page 36 and 37: RS232 port RS485 port 32
Page 38 and 39: 7 User operations 7.1 Single machin
Page 40 and 41: 5)Press ▼ again to obtain the bel
Page 42 and 43: 3)Select “Yes, Confirm” to swit
Page 44 and 45: 5)Select “Yes, Confirm” to swit
Page 46 and 47: 9. Procedures of DC switch-on: 42 A
Page 48 and 49: Single machine wire connection draw
Page 50 and 51: 8.1 Regular service/intervals The U
Page 54 and 55: 11 Warranty The product is warrante
Page 56: Should any display or warning messa

Eaton E Series DX Product Manual - Fusion Power System

Create successful ePaper yourself

Delete template?

Save as template?