2.5.2 - Force10 Networks

4. Use the show spanning-tree command to verify the STP convergence (see Figure 118 on page 167)
and show spanning-tree mst port summary command (see Figure 124 on page 170) for
behaviour of ports participating in the spanning tree.
Note: Another configuration example is in Example of configuring STP on page 160.
Display Spanning Tree Configuration
Use the following commands to display MSTP configuration.
Command Syntax Command Mode Purpose
show spanning-tree summary Privileged Exec Display STP settings and parameters for the
switch. See Figure 115 on page 166.
show spanning-tree [brief] Privileged Exec Display settings and parameters for the CIST.
See Figure 117 on page 166.
show spanning-tree mst summary Privileged Exec Display settings and parameters for all MST
instances.
show spanning-tree mst detailed
mstid
Privileged Exec Display settings and parameters for one MST
instance.
show spanning-tree vlan vlanid Privileged Exec Display the association between an MST
instance and a VLAN. See Figure 124 on
page 170.
show spanning-tree interface unit/
slot/port
show spanning-tree mst port
summary mstid {unit/slot/port | all}
show spanning-tree mst port
detailed mstid unit/slot/port
Privileged Exec Display settings and parameters for a port within
the CIST. See Figure 115 on page 166.
Privileged Exec Display settings and parameters for one MST
instance. See Figure 123 on page 170.
Privileged Exec Display settings and parameters for a specific
port within a particular MST instance. See
Figure 120 on page 168
SFTOS Configuration Guide, Version 2.5.2.0 165