Blind actuator 1-gang flush-mounted Order-No. 2165 00 - Gira

Software "Venetian blind, input 20BD11"
Functional description
Figure 9: Example to change the value for dimming value encoder
i There is no value over- or underrun on adjustment. If, during an adjustment, the maximum
or minimum value is reached (see Table 3), no more telegrams are transmitted.
i To ensure that, during a value adjustment, for example the controlled lighting switches off
or switches on at the maximum, the limit values (e.g. the values "0" or "255") are always
transmitted when the limits of the adjustable range are reached. This also takes place
when the configured step width of these values is not immediately taken into account (see
example above: step width = 5; value "2" is transmitted, then value "0").
In this case, to ensure that the original starting value can be reset on resetting with a
change to the adjustment direction, the first value jump is not equal to the preset step width
(see example above: step width = 5; value "0" is transmitted, then values "2"; "7" etc.).
i The newly adjusted values are stored in RAM. After a device reset (bus voltage failure or
ETS programming operation), the adjusted values are replaced by the values originally
configured in the ETS.
Light scene extension
With a configuration as a light scene extension without a memory function, it is possible to recall
a light scene, which is stored in an external bus subscriber (e.g. light scene pushbutton sensor)
With a rising, falling or rising and falling flank, the light scene number configured in the ETS is
immediately transmitted to the bus.
With a configuration as a light scene extension with a memory function, it is possible to
generate a memory telegram according to the light scene to be transmitted. For this, the
appropriate memory telegram is transmitted for a long signal according to the configured flank
evaluation (pushbutton as NC contact or NO contact - not as switch!). In this case, the time for
long actuation can be configured (but not to below 5 s). With short actuation < 1 s, the
configured light scene number (without memory telegram) is transmitted. If the actuation last
longer than 1 s but less than 5 s, no telegram is triggered.
In addition, there is the option of only transmitting a memory telegram without prior light scene
recall. In this case, the parameter "Only memory function ?" must be set to "Yes".
Examples for a light scene extension with memory function (Figure 10):
1.) Only memory function = No
2.) Only memory function = Yes
Order-No. 2165 00
Page 34 of 149