Blind actuator 1-gang flush-mounted Order-No. 2165 00 - Gira

Installation, electrical connection and operation
i The sequence of the connections on the device for mains voltage (L) and load (o)
depends upon the device version. The device versions can be recognised by the different
connection labelling in the housing print images. Furthermore, a version identification in
text form is added in the print images.
Devices with no version labelling or with the labelling "V02" must be connected in
accordance with connection diagram A. Devices with the version labelling "V01" must be
connected in accordance with connection diagram B.
The colour assignment of the connecting wires is the same for both device versions.
o Connect the device to KNX. For this, use a KNX connection terminal.
o If necessary, connect potential-free contacts to the inputs (Figure 5).
i Use suitable terminals to connect potential-free contacts to the control cable.
i The reference potential "com" may only be switched together with the reference potentials
of other devices of the same type (!).
Figure 5: Connection of the extension inputs
o Install the device in a flush-mounted box.
i Venting louvres must be connected in such a way that they open in travel direction "UP -
n" and close in travel direction "DOWN – o".
i Do not connect any three-phase motors.
i Insulate unused wires of the 6-pin control cable against each other and outside voltage.
i To avoid interference from EMC radiation, the cables of the extension inputs should not be
run in parallel to cables carrying voltage.
Order-No. 2165 00
Page 8 of 149