Blind actuator 1-gang flush-mounted Order-No. 2165 00 - Gira
Blind actuator 1-gang flush-mounted Order-No. 2165 00 - Gira
Blind actuator 1-gang flush-mounted Order-No. 2165 00 - Gira
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2 Installation, electrical connection and operation<br />
2.1 Safety instructions<br />
Electrical equipment may only be installed and fitted by electrically skilled persons. The<br />
applicable accident prevention regulations must be observed.<br />
Failure to observe the instructions may cause damage to the device and result in fire and<br />
other hazards.<br />
Before working on the device or exchanging the connected loads, disconnect it from the<br />
power supply (switch off the miniature circuit breaker), otherwise there is the risk of an<br />
electric shock.<br />
The device is not suitable for disconnection from supply voltage.<br />
Make sure during the installation that there is always sufficient insulation between the<br />
mains voltage and the bus and extension inputs. A minimum distance of at least 4 mm<br />
must be maintained between bus/extensions and mains voltage cores.<br />
Do not connect any external voltage to the inputs, since doing so may damage the<br />
device(s), and the SELV potential on the KNX bus line will no longer be available.<br />
For parallel connection of several drives to a shutter / blind output it is indispensable to<br />
observe the corresponding instructions of the manufacturers, and to use a cutoff relay if<br />
necessary. There is otherwise risk of irreparable damage to the drives.<br />
Use only curtains with mechanical or electronic limit switches. Check the limit switches<br />
for correct adjustment.<br />
Do not connect any three-phase motors.<br />
Installation, electrical connection and operation<br />
The device may not be opened or operated outside the technical specifications.<br />
<strong>Order</strong>-<strong>No</strong>. <strong>2165</strong> <strong>00</strong><br />
Page 4 of 149