capriz 25 capriz 28 - Heatline

02
Preface
The Heatline gas fired, condensing combination
boiler meets the requirements of all appropriate
regulations and is deemed to meet the requirements of:
Gas Appliance Directive 90/396/EEC
Efficiency Directive 92/42/EEC
Low Voltage Directive 73/23 EEC (modified from 93/68)
Electromagnetic Compatibility Directive 89/396 EEC
(modified from 93/68)
Heatline declares that the materials used in the
manufacturer of this appliance are non-hazardous and
that no substances harmful to health are contained
within the appliance.
Manual Handling:
As this appliance is heavy it is recommended that you
get assistance when lifting. When manoeuvring the
boiler always use safe techniques – keep your back
straight, bend your knees, don’t twist, move your feet.
Avoid bending forwards or sideways and keep the load
as close to your body as possible. Where possible
transport the boiler using a suitable trolley, sack truck
or get some assistance. Grip the boiler firmly and
before lifting establish where the weight is concentrated
to determine the centre of gravity, repositioning yourself
if necessary
Warnings
Heatline accepts no responsibility for the
unsatisfactory performance of the appliance or flue
arising from the failure to comply with the installation
and user instructions. Incorrect installation could
invalidate your guarantee and may lead to prosecution.
If the boiler is sold to another customer, all documents
must be transferred from existing customer to the new
one and the appliance must be re-registered with
Heatline in order to maintain the guarantee.
The boiler must be installed in accordance with these
instructions and all the regulations currently in force.
Read these instructions carefully before installing or
using the appliance.
SHOULD YOU SMELL GAS: Turn the gas valve off at the
Gas Meter or Gas Cylinder, ventilate the room by opening
windows and doors (EXTINGUISH ANY NAKED FLAMES,
DO NOT OPERATE ANY ELECTRICAL SWITCHES) and call
Transco on 0800 111 999 or if you use LPG call your gas
supplier.
IMPORTANT NOTE
Speed 2 is the factory default setting
for the Pump.
This setting should be suitable for
most of your applications.
1
2
3
NOTE: Cables on the cap ; 1- Ionisation cable
2 - Earth cable
3 - Condensate hose
Page 2