capriz 25 capriz 28 - Heatline
capriz 25 capriz 28 - Heatline
capriz 25 capriz 28 - Heatline
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
1. Installation Regulations<br />
1.1.<br />
1.2.<br />
Correctly may invalidate your guarantee and may<br />
lead a dangerous situation.<br />
Your CORGI registered engineer should carry a<br />
CORGI ID card containing their registration<br />
number, which should be recorded in your<br />
BENCHMARK Log Book, which is supplied with<br />
the Instructions. You can check the validity of<br />
this ID number by contacting CORGI on 0800 915<br />
0480.<br />
1.3. This appliance must be installed in accordance<br />
with the Gas Safety (Installation and Use)<br />
Regulations, current Building Regulations,<br />
Building Standards (Scotland), I.S.813 Installation<br />
of Gas Appliances (Ireland), IEE Wiring<br />
Regulations (BS 7671), Health and Safety<br />
Document No. 635 (Electricity at Work<br />
Regulations) and Local Water Authority Bye<br />
Laws.<br />
For further information or advice (UK) contact <strong>Heatline</strong> TM :<br />
Service please call: 0870 609 2091<br />
Spares please call: 0870 777 8402<br />
Technical assistance please call: 0870 777 8318<br />
Or by E mail on our Web Site at www.heatline.co.uk<br />
04<br />
1.4. On installation the following British Standards<br />
must also be considered:<br />
BS 6798 Specification for installation of gas<br />
fired hot water boilers of rated input not<br />
exceeding 70kW.<br />
BS 5449 Central heating for Domestic<br />
Premises.<br />
BS 5546 Installation of gas hot water supplies<br />
for domestic purposes.<br />
BS 5440 Flues and Ventilation for gas<br />
appliances of rated input not exceeding 70kW<br />
(Part 1 Flues)<br />
BS 5440 Flues and Ventilation for gas<br />
appliances of rated input not exceeding 70kW<br />
(Part 2 Air Supply)<br />
BS 6891 Installation of low pressure gas pipework<br />
installations up to <strong>28</strong>mm (R1¼).<br />
Reference should also be made to British Gas<br />
Guidance Notes for Installation of Domestic Gas<br />
Fired Boilers.<br />
1.5. Due to the manufacturer’s continuous<br />
improvement policy the manufacturer reserves<br />
the right to change any specification of the<br />
appliance or make modifications to these<br />
instructions, which meet current regulations at<br />
the time of print. However, the instructions must<br />
not be taken as overriding statutory<br />
requirements.<br />
1.6. To ensure reliability and continued performance<br />
ensure that other components in the system are<br />
also approved to relevant standards and that the<br />
appliance and system is adequately protected<br />
and maintained on an annual basis.<br />
Page 4
Change language