VDX104 Manual - Tri-M Systems Inc.

18-Nov-2010
VDX104 Manual
12.4 IDE Controller Configuration
Advanced
* IDE Configuration * Options *
* *************************************************** * *
* OnBoard PCI IDE Controller [Primary] * Disabled *
* * Primary *
* * Primary IDE Master [Hard Disk] * Secondary *
* * Primary IDE Slave [Not Detected] * Both *
* * Secondary IDE Master [Not Detected] * *
* * Secondary IDE Slave [Not Detected] * *
* * *
* Hard Disk Write Protect [Disabled] * *
* IDE Detect Time Out (Sec) [35] * *
* ATA(PI) 80Pin Cable Detection [Host & Device] * *
* Hard Disk Delay [2 Second] * ** Select Screen *
* OnBoard IDE Operate Mode [Legacy Mode] * ** Select Item *
* Primary IDE Pin Select [Parallel IDE] * +- Change Option *
* Standard IDE Compatible [Disabled] * F1 General Help *
* * F10 Save and Exit *
* * ESC Exit *
* * *
* * *
********************************************************************************
v02.58 (C)Copyright 1985-2008, American Megatrends, Inc.
Figure 6: IDE Controller Configuration.
On-Board PCI IDE Controller has to be set to PRIMARY only, the secondary is not available on this board.
Primary IDE Master/Slave is auto-detected but can also be set manually through the sub-menu. Secondary
IDE Master/Slave is unused.
Hard Disk Write Protect: will deny any write to the device when enabled.
IDE Detect Time Out: set the maximum time in sec. the BIOS will try to auto-detect the connected device.
ATA(PI) 80Pin Cable Detection: will allow high speed DMA transfer when 80 pins cable connected.
Hard Disk Delay: set the time the BIOS will wait for a device to be ready.
OnBoard IDE Operate mode: set the I/O and memory addresses of the IDE interface. Legacy uses the
standard addresses of an IDE controller when Native will use the 8212 controller native addresses.
Primary IDE Pin Select: allows to select between standard hard-drive signals and SD interface. An external
module is required to interface with an SD card.
Standard IDE Compatible: select enable or disable .
Tri-M Technologies Inc. Tel: 800.665.5600, 604.945.9565
1407 Kebet Way, Unit 100 Fax: 604.945.9566
Port Coquitlam, BC V3C 6L3 E-mail: info@tri-m.com
Canada Web site: www.tri-m.com 43