Glacier Transportable Sampler - Isco

Glacier Transportable Sampler
Section 2 Installation
Generally when you start a program, the Glacier will attempt to
take its first sample at the start time—unless the first sample is
delayed or inhibited. See sections 4.3 and 4.4 for more information
on delayed or inhibited sampling programs.
If the Glacier requires programming before you start the sampling
program, refer to Section 3 for instructions.
2.12 Secure the Glacier After starting the program, the protective cover should be
replaced over the controller.
If the Glacier is in a location where tampering or theft is a possibility,
it is advisable to:
• Prevent access to the sampling program by using the
Program Lock option. See section 3.8.1 for more information
on this factory-installed option.
• Prevent access to the sampler controller and refrigerated
compartment. Use the Glacier Locking Kit,
68-2960-011, to secure the covers. The locking cables
thread through the locking loops on the sides of the
Glacier, and is secured in the center with a lock.
• Secure the Glacier to a immovable, permanent object
nearby. A locking cable, such as bicycle locking cables
available from most hardware stores, may be threaded
through a locking loop or carrying handle to secure your
sampler.
2-19