isel-CNC Machine - Bedienungsanleitungen / Manuals isel

isel-CNC Machine CPV
4.4 Opening the Cover
During commissioning, carry out the following steps:
- To open the cover, connect the mains cable and turn on the mains switch (on the rear side).
Make sure that the control computer is ready for operation.
Either start the operating software or the cover.exe file from the installation diskette
ISELDRV V3.2. Set the key-operated switch to TEST mode. The COVER key ➅ should now
light; open the cover only if this key lights.
To enable the following functions, make sure that the EMERGENCY STOP button is
unlocked. Return to AUTOMATIC mode.
- Close the cover and press the POWER key ➁ to turn on the output stage; the push-button
must light.
- The spindle motor can be turned on in AUTOMATIC mode only if the POWER key lights,
the cover is closed and locked and if the software communicates with the machine.
- During the machining, the cover is locked. You can only open the cover if the machine has
been stopped, the spindle motor is switched off, the machine is in home position and the
software allows the cover to be opened (COVER key lights).
- To open the cover, push the COVER key. If the cover has been closed, it will be locked
automatically. To start the machine, push the START key again.
Key-operated switch
To test the program, you can nevertheless open the cover during operation if you turn the
key-operated switch to TEST.
The working program stops the drive axes immediately and goes on running if you hold
down the START key.
This key may only be used by expert and authorised personnel since after opening the
cover no more protection against moving machine parts is provided.
14