isel-CNC Machine - Bedienungsanleitungen / Manuals isel

isel-CNC Machine CPV
To lubricate the Y axis, move* the T-slot
plate completely to the back and then
remove from the Y axis (six screws).
Remove the plastic plug beneath and
lubricate through the lubricating nipple,
which now becomes visible.
Access to the guide rails is provided
through the sealing lips.
S
To remove the cover sheet of the Y axis,
loosen all fastening screws.
S marks the access to the lubricating points in all drawings.
To lubricate the X axis, move the
carriage to the left*, remove the
plastic plug on the left-hand side of
the machine and lubricate through
the lubricating nipple, which now
becomes visible.
Access to the guides rails is provided
through the sealing lips.
S
First, remove the spindle motor from the Z axis, remove
the three plugs and push the carriage completely down*.
Apply some oil to the guide rails through the two side
holes.
The lubricating nipple for the drive is now behind the front
opening.
* If the machine is switched off you can
move the carriage manually.
16