isel-CNC Machine - Bedienungsanleitungen / Manuals isel

isel-CNC Machine CPV
2 Safety Notes
- Do not operate the machine in potentially explosive atmospheres.
- The machine is completely encapsulated. The casing protects you against moving tools,
decreases the operating noise level and restrains the chips.
- On machining, the cover is locked and cannot be opened.
You may neither remove nor modify this protection measure.
- For emergency situations, you find an Emergency Stop switch on the front-panel of the
machine.
It interrupts the power supply to the power outputs and to the converter of the main
spindle drive. The converter therefore no longer provides a brake voltage, and the spindle
motor slowly runs down.
- The system should not often be restarted/shut down. Wait at least 60 seconds before you
turn on the system again.
- Only experts and trained persons may handle the key-operated switch because of
increased hazards in test mode.
Please, keep the spare key under lock and key.
- Provide sufficient ventilation at dust or gas development caused by the machining of the
materials.
- If you want to use a laser for measuring applications, use only suitable devices (laser class
2) and observe the relevant technical regulations and safety instructions.
- For cooling, no flowing water may be used but only a sprinkling/chilling appliance with
which a spray causes the cooling effect (see Accessories).
Make sure that no drops form and flow under the clamping plate.
- Do not use spirit as a coolant (explosion hazard).
- Clean the machine at regular intervals and remove chips and dust deposits. Do not use
aggressive cleaning agents or solvents that may damage the paint or the plastic washers.
6