Installation Instructions - KACO new energy, Inc.
Installation Instructions - KACO new energy, Inc.
Installation Instructions - KACO new energy, Inc.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Configuration and Operation<br />
Menu<br />
level<br />
Display/settings<br />
0 1 2 3<br />
Ethernet<br />
Action in this menu/meaning<br />
Assign a unique IP address.<br />
Assign a subnet mask.<br />
Assign a gateway.<br />
0 1 2 3<br />
Webserver<br />
<br />
Activate or deactivate the integrated webserver.<br />
0 1 2 3<br />
“Parameters” menu<br />
0 1 2 3<br />
Country<br />
0 1 2<br />
Grid type/<br />
3<br />
guideline<br />
0 1 2 3<br />
DC starting volt.<br />
0 1 2 3<br />
Const. volt. ctrl<br />
0 1 2 3<br />
“Information” menu<br />
Press the right arrow key or the OK key.<br />
NOTICE: The inverter does not display the “Parameters” menu in<br />
the standard configuration. To display the menu:<br />
1. Open the menu.<br />
2. Simultaneously hold down the up and down keys for several<br />
seconds.<br />
1. Input the four-character password via the 4-way key. The<br />
password is unit-specific.<br />
2. Confirm the entry with the OK key.<br />
3. Set the desired country setting.<br />
NOTICE: This option influences the country-specific operating<br />
settings of the inverter. Please consult <strong>KACO</strong> service for further<br />
information.<br />
If available, select the type of grid applicable to the use of the<br />
inverter.<br />
The inverter begins feed-in as soon as this PV voltage is present.<br />
<br />
Set the starting voltage.<br />
Offers the possibility of deactivating the MPP seek mode in order<br />
to operate the inverter with a constant DC voltage.<br />
<br />
Activate or deactivate MPP seek mode.<br />
Set value for constant voltage control (200 - 800 V).<br />
NOTICE: The possible input power is reduced at voltages lower<br />
than 350 voltage. The input current is limited to 18.6 A per input.<br />
<br />
Open the menu: Press the right arrow key or<br />
the OK key.<br />
0 1 2 3<br />
Inverter type Displays the type designation of the inverter.<br />
0 1 2 3<br />
SW version Displays the installed software version.<br />
0 1 2 3<br />
Serial number Displays the serial number of the inverter.<br />
0 1 2 3<br />
Display country<br />
0 1 2 3<br />
“Vendor” menu<br />
Displays the selected country setting.<br />
Optional: Displays the grid type if a grid type has been selected.<br />
» The display shows information about the unit manufacturer.<br />
Page 32 <strong>Installation</strong> <strong>Instructions</strong> blueplanet XP10U-H4