Book template - KISSsoft AG

More documents

Recommendations

Info

Chapter 1 I-48 Description of the calculation modules
Chapter 1 I-49 Description of the calculation modules 4.15 M09a Glued and Soldered Joints Glued joint: Calculation basis: G. Niemann, Maschinenelemente, Volume I, 1981. The calculation of glued joints is performed for joints that are subject to shear load. Two different load cases are described: Shearing force: Transmission of shearing force between two surfaces Torque: shaft hub joint with a torque load The joint can be subject either to static or dynamic (usually pulsating) load. You can select adhesives (extendable database) that harden at room temperature or at higher temperatures. Sizings: Sizing the adhesion width (for shaft hub), or the adhesion length (for brackets), on the basis on the strength of the underlying material. The tear resistance of the connection is set so that it corresponds to the tear resistance of the underlying material or the fatigue strength under pulsating stress of the shaft. Sizing the adhesion width on the basis of stress: The tear resistance of the joint is sized so that it can withstand the forces it is subjected to without compromising the specified safety. Soldered joint Calculation basis: G. Niemann, Maschinenelemente, Volume I, 1981. The calculation is performed for soldered joints that are subject to shear load. Two different load cases are described: Shearing force: Transmission of shearing force between two surfaces Torque: shaft hub joint with a torque load The joint can be subject either to static or dynamic (usually pulsating) load. You can select any material (extendable database): Soft solder LSn40, LSn60 for short-term loads Soft solder LSn40 for a permanent load Brass solder: Steel NE heavy metals New silver solder, copper: steel Silver solder: Steel NE heavy metals Sizings:
Page 1: aa KISSSOFT RELEASE 03/2011 PRODUCT
Page 5 and 6: Inhalt Table of Contents I Descript
Page 7 and 8: Inhalt 3.25 W07b calculation accord
Page 9 and 10: Inhalt 6.31 Z05d Calculate the toot
Page 11 and 12: Inhalt 7.2 Z91 Toothed belts (Z091)
Page 13 and 14: Chapter 1 I-13 Description of the c
Page 47: Chapter 1 I-47 Description of the c
Page 99 and 100:
Chapter 1 I-99 Description of the c
Page 101 and 102:
Chapter 1 I-101 Description of the
Page 103 and 104:
Chapter 1 I-103 Description of the
Page 105 and 106:
II Inde x Chapter 1 II-105 Descript
Page 107 and 108:
Chapter 1 II-107 Description of the
Page 109 and 110:
Page 111:
show all

Book template - KISSsoft AG

Create successful ePaper yourself

Delete template?

Save as template?