Service Manual PLATINUM ENG.pdf

More documents

Recommendations

Info

Ideas with Passion 5.4 Problems, causes, remedies HELP MESSAGES DISPLAYED Turn the appliance off and on to solve the problem. Call the Service Center. Insert drip tray. Close coffee granule container cover. Insert ground coffee. Insert brew group. Insert coffee grounds drawer. Empty coffee grounds drawer. Close side door Fill water tank. Empty drip tray below brew group. Insert milk container. Prime circuit. The descaling cycle did not run correctly. Replace Aqua Prima filter. The cleaning cycle did not run correctly. Insert cappuccinatore. Rinse milk container. Descale appliance. Standby. HOW TO RESET MESSAGE Switch off and after 30 sec. turn on the appliance to restore normal operating conditions. Problem requiring assistance of Service Center. Insert drip tray. Close the coffee granule container to enable delivery of any beverage. This message guides the user when this type of coffee has been selected during personalised beverage programming. Insert brew groupin seat. Insert coffee grounds drawer. Remove coffee grounds drawer and empty. N.B: The coffee grounds drawer must only be emptied when the appliance is switched on. The drawer must be removed for at least 5 seconds. If the drawer is emptied when the appliance is switched off the message is not reset. Close service door. Fill tank. Empty drip tray. Insert container in milk compartment. Start filling water circuit automatically. The appliance will automatically try to fill the circuit 5 times; if it fails, contact the Service Centre. Repeat the operation as described in the relative chapter in the instruction booklet. This message is only displayed if the filter control is enabled (see instruction booklet). Replace the filterif: 1) 60 litres of water have been dispensed. 2) 90 days have elapsed since installation. 3) 20 days have elapsed since the coffee maker was last used. Repeat the operation as described in the relative chapter in the instruction booklet. Insert cappuccinatore in milk compartment. Clean container after use. Run descaling cycle Press “ start”. PRIMEA Section 05 REV00 - August 06 17/17
SECTION 6 OPERATING LOGIC TALEA Section 06 REV.00 REV00 - August 06
Page 1 and 2: TECHNICAL SERVICE MANUAL Emissione
Page 3 and 4: SECTION 1 INTRODUCTION TALEA Sectio
Page 5 and 6: Ideas with Passion 1.4 Platinum ran
Page 7 and 8: SECTION 2 TECHNICAL DATA TALEA Sect
Page 9 and 10: Internal components Heater Pump Sta
Page 11 and 12: Ideas with Passion 3.1 Client and p
Page 13 and 14: Ideas with Passion 3.2 Maintenance
Page 15 and 16: Ideas with Passion 4.1 Wiring diagr
Page 17 and 18: Ideas with Passion Platinum Swing 3
Page 19 and 20: Ideas with Passion 4.2 Platinum wat
Page 21 and 22: Ideas with Passion - Milk island pr
Page 23 and 24: Ideas with Passion Platinum Swing e
Page 25 and 26: Ideas with Passion Level M4 At this
Page 27 and 28: Ideas with Passion Messages/Alarms
Page 29 and 30: Ideas with Passion POSITION POTENTI
Page 31 and 32: Ideas with Passion DIP SWITCH ON ON
Page 33 and 34: Ideas with Passion Level M3 : Error
Page 35: Ideas with Passion 5.3 Error messag
Page 39 and 40: Ideas with Passion 6.3 Motorized tr
Page 41 and 42: Ideas with Passion 6.5 SBS Valve Be
Page 43 and 44: Ideas with Passion 6.6 Solenoid pil
Page 45 and 46: Ideas with Passion SECTION 7 COMPON
Page 47 and 48: Unscrew the four screws which block
Page 49 and 50: Ideas with Passion 7.3 Electronics
Page 51 and 52: Ideas with Passion 7.5 Pump 1 2 Tak
Page 53 and 54: Ideas with Passion 7. 7 OETIKER cla
Page 55 and 56: 7.9 Coffee grinder setting, assembl
Page 57 and 58: Ideas with Passion 7.11 Motorized d
Page 59: Ideas with Passion 8.1 Routine main

Service Manual PLATINUM ENG.pdf

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?