Service Manual PLATINUM ENG.pdf

More documents

Recommendations

Info

Ideas with Passion 7.6 Heater and solenoid pilot unit Loosen the screws as indicated. A B C Take off the oetiker clamp A, pull out the reinforced flexible hose, loosen screw B and withdraw the drain pipe C from the solenoid pilot. Loosen the screws on the relief valve assembly. A Heater Unhook the teeth anchoring to the body and lift the heater and solenoid pilot. Solenoid pilot. TALEA Section 07 REV00 - August 06 6/11
Ideas with Passion 7. 7 OETIKER clamp assembly and disassembly Heater clamps 1 HEATER Figure (1) shows the assembly position of the clamp on the heater connector. Solenoid pilot 2 SOLENOID PILOT Figure (2) shows the assembly position of the clamp on the plastic solenoid pilot connectors. A Use suitable pliers to tighten the clamp. Ensure correct tightening (A) and positioning as shown in illustrations (1) / (2). B To remove the clamp, use a pincer as shown in (B) TALEA Section 07 REV00 - August 06 7/11
Page 1 and 2: TECHNICAL SERVICE MANUAL Emissione
Page 3 and 4: SECTION 1 INTRODUCTION TALEA Sectio
Page 5 and 6: Ideas with Passion 1.4 Platinum ran
Page 7 and 8: SECTION 2 TECHNICAL DATA TALEA Sect
Page 9 and 10: Internal components Heater Pump Sta
Page 11 and 12: Ideas with Passion 3.1 Client and p
Page 13 and 14: Ideas with Passion 3.2 Maintenance
Page 15 and 16: Ideas with Passion 4.1 Wiring diagr
Page 17 and 18: Ideas with Passion Platinum Swing 3
Page 19 and 20: Ideas with Passion 4.2 Platinum wat
Page 21 and 22: Ideas with Passion - Milk island pr
Page 23 and 24: Ideas with Passion Platinum Swing e
Page 25 and 26: Ideas with Passion Level M4 At this
Page 27 and 28: Ideas with Passion Messages/Alarms
Page 29 and 30: Ideas with Passion POSITION POTENTI
Page 31 and 32: Ideas with Passion DIP SWITCH ON ON
Page 33 and 34: Ideas with Passion Level M3 : Error
Page 35 and 36: Ideas with Passion 5.3 Error messag
Page 37 and 38: SECTION 6 OPERATING LOGIC TALEA Sec
Page 39 and 40: Ideas with Passion 6.3 Motorized tr
Page 41 and 42: Ideas with Passion 6.5 SBS Valve Be
Page 43 and 44: Ideas with Passion 6.6 Solenoid pil
Page 45 and 46: Ideas with Passion SECTION 7 COMPON
Page 47 and 48: Unscrew the four screws which block
Page 49 and 50: Ideas with Passion 7.3 Electronics
Page 51: Ideas with Passion 7.5 Pump 1 2 Tak
Page 55 and 56: 7.9 Coffee grinder setting, assembl
Page 57 and 58: Ideas with Passion 7.11 Motorized d
Page 59: Ideas with Passion 8.1 Routine main

Service Manual PLATINUM ENG.pdf

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?