Service Manual PLATINUM ENG.pdf

More documents

Recommendations

Info

2.1 Product technical data Power supply and output: 230 V~, 50/60 Hz, 1300 W. Temperature control: 1 (NTC) variable resistor sensor – transmits the value to the electronic board. Safety system: 2 x 175°C manual reset thermostats. Coffee heat exchanger output: 1300 W – to dispense coffee, hot water and steam. Stainless steel Motorized tank only on 24V stepper motor. Platinum Vision e Swing Up Water level and drip Capacitive sensor tray sensor: Gearmotor: 33VC with 2 directions of rotation. Cup warmer plate: Solo Platinum Vision e Swing Up Activated via MENU display. PTC Type. Pump: Ulka reciprocating piston type with thermal cutout at 100°C, 48 W, 230V, 50 Hz, Type EX5 approx. 13-15 bars. Pressure relief valve: Opening at approx. 18-20 bars. Water filter: In tank. Coffee grinder: DC motor with ceramic plate grinders. Solenoid pilot: 15 VA. Coffee dose control: Hall sensor – Pulse control. Dose adjustment can be set from approx. 7 to 10.5 g. Amps: During heating phase- approx. 5.6 A. Dimensions: l x h x d in mm: 310/390/440 Weight: 10 kg (average). Water tank capacity: 1.7 l. Coffee container capacity: 250g coffee granules. Coffee grounds drawer capacity: 14 Heatex changer capacity: Approx. 10 cc. Water circuit filling time: Approx. 15 sec on first filling cycle. Heating time: Approx. 45 sec. Dispensed drink temperature: Approx. 73°C - 83°C Grinding time: Approx. 8-10 sec. TALEA Section 02 REV00 - August 06 1/4
Internal components Heater Pump Static eliminator Turbine Power board CPU Card Coffee grinder Solenoid pilot Motorized tank stepper motor on 02 REV00 - August 06 4/4
Page 1 and 2: TECHNICAL SERVICE MANUAL Emissione
Page 3 and 4: SECTION 1 INTRODUCTION TALEA Sectio
Page 5 and 6: Ideas with Passion 1.4 Platinum ran
Page 7: SECTION 2 TECHNICAL DATA TALEA Sect
Page 11 and 12: Ideas with Passion 3.1 Client and p
Page 13 and 14: Ideas with Passion 3.2 Maintenance
Page 15 and 16: Ideas with Passion 4.1 Wiring diagr
Page 17 and 18: Ideas with Passion Platinum Swing 3
Page 19 and 20: Ideas with Passion 4.2 Platinum wat
Page 21 and 22: Ideas with Passion - Milk island pr
Page 23 and 24: Ideas with Passion Platinum Swing e
Page 25 and 26: Ideas with Passion Level M4 At this
Page 27 and 28: Ideas with Passion Messages/Alarms
Page 29 and 30: Ideas with Passion POSITION POTENTI
Page 31 and 32: Ideas with Passion DIP SWITCH ON ON
Page 33 and 34: Ideas with Passion Level M3 : Error
Page 35 and 36: Ideas with Passion 5.3 Error messag
Page 37 and 38: SECTION 6 OPERATING LOGIC TALEA Sec
Page 39 and 40: Ideas with Passion 6.3 Motorized tr
Page 41 and 42: Ideas with Passion 6.5 SBS Valve Be
Page 43 and 44: Ideas with Passion 6.6 Solenoid pil
Page 45 and 46: Ideas with Passion SECTION 7 COMPON
Page 47 and 48: Unscrew the four screws which block
Page 49 and 50: Ideas with Passion 7.3 Electronics
Page 51 and 52: Ideas with Passion 7.5 Pump 1 2 Tak
Page 53 and 54: Ideas with Passion 7. 7 OETIKER cla
Page 55 and 56: 7.9 Coffee grinder setting, assembl
Page 57 and 58: Ideas with Passion 7.11 Motorized d
Page 59:
Ideas with Passion 8.1 Routine main
show all

Service Manual PLATINUM ENG.pdf

Create successful ePaper yourself

Delete template?

Save as template?