BAM 210 Operation Manual - Peavey.com

More documents

Recommendations

Info

BAM 210 BLOCK DIAGRAM 20
BAM SPECIFICATIONS SYSTEM SPECIFICATIONS: GENERAL: • Mains circuit breaker: 6 amps (resettable) • Power consumption: 500 Watts, 120 VAC 60 Hz • Power consumption: 500 Watts, 230 VAC 50/60 Hz • Hum and noise: Typically greater than -80 dB unweighted • Internal speakers: Two professional 10 inch cast frame 8-Ohm speakers wired in parallel for a total impedance of 4 Ohms. One Foster compression horn with crossover and tweeter protection. DIMENSIONS: • Height: 24 inches (including feet) • Width: 23.5 inches • Depth: 17.125 inches @ bottom, 13 inches @ top • Weight: 93.5 lbs POWER AMPLIFIER SECTION: PROTECTION: • Current limit protection circuit • Thermal protection circuit • D.C. crowbar • DDT speaker protection circuit with defeat switch • Variable speed fan, thermally controlled GENERAL INFO: • Minimum load = 2 Ohms • DDT dynamic range: +16 dB • Input sensitivity: 1.0 V RMS • One 1/4 inch external speaker jack POWER AMPLIFIER INPUT: • Input impedance: 15 k Ohms • Sensitivity: 1 V RMS (to drive power amp to clipping) • Switching jack provides preamp out to power amp in connection when not used POWER OUTPUT: • 500 Watts (31.62 V RMS) into 2 Ohms with no more than 1% THD+N • 350 Watts (37.42 V RMS) into 4 Ohms with no more than 1% THD+N PREAMPLIFIER SECTION: D/A AND A/D CONVERSION: • Rate: 44.1 kHz • Quantization: 24 bit SETTINGS FOR FOLLOWING MEASUREMENTS UNLESS OTHERWISE NOTED: • Input trim set to highest level without triggering red clip indicator • Compressor = Out • Pre-gain = Not applicable to this model • Bass = 0 (12 o’clock) • Mid = 0 (12 o’clock) • Mid-shift = 0 (12 o’clock) • High = 0 (12 o’clock) • Post-gain = 5 • Effects = Off • Amp model = RED • Speaker model = BAM 210 INPUT SENSITIVITY (Level to achieve full power): • Nominal input: 300 mV RMS • Minimum input: 25 mV RMS (input trim, post-gain and master fully CW) • Maximum input: 7 V RMS (maximum signal at input before preamp clipping occurs) PREAMP OUTPUT: • Nominal output level: 1 V RMS • Load impedance: 1,000 Ohms minimum EXTERNAL FOOTSWITCH FUNCTIONS: • Preset/bank selection • Remote tuner access/display • Tweeter on/off selection • Effects on/off selection • Effects alternate settings • Compressor on/off • Boost function (Allows alternate level and EQ settings) HUM AND NOISE: • Typically greater than 100 dB below full power @ 4 Ohms unweighted FREQUENCY RESPONSE: • +0/-1 dB, 100 mW to 300 W RMS 20 Hz to 20 kHz into 4 Ohms Specifications are subject to change without notice. 21
Page 1 and 2: BAM 210 Operation Manual For more i
Page 3 and 4: ENGLISH BAM 210 BASS MODELING AMP
Page 5 and 6: (5) USER This control determines wh
Page 7 and 8: (15) EQUALIZATION The EQ on the BAM
Page 9 and 10: (28) MIDI IN / FOOTSWITCH This 8-pi
Page 11 and 12: BANK SELECT MODE Pressing button 37
Page 13 and 14: DETAILS PRESET: • Analog Overdriv
Page 15 and 16: PRESET BACKUP You can back your pre
Page 17 and 18: Partial addressing is a way of prog
Page 19: GLOBALS Offset Name Range (Decimal)
Page 23 and 24: desempacada por primera vez y conec
Page 25 and 26: modelo está activo (rojo = modelo
Page 27 and 28: PANEL TRASERO 23 26 27 28 29 30 31
Page 29 and 30: En el modo de bajo, el afinador bus
Page 31 and 32: Los LEDs verdes indican la nota que
Page 33 and 34: EFFECT PARAMETERS / TWEAKS Effect S
Page 35 and 36: Todos los mensajes sysex del BAM co
Page 37 and 38: *** La dirección “actual” un m
Page 39 and 40: GLOBALS Offset Name Range (Decimal)
Page 41 and 42: FRANÇAIS BAM 210 AMPLIFICATEUR DE
Page 43 and 44: (5) USER L’interrupteur User perm
Page 45 and 46: caractéristique permet de reprodui
Page 47 and 48: (31) PREAMP OUT Ce jack 1/4" vous p
Page 49 and 50: EFX SELECT MODE Pour passer en mode
Page 51 and 52: DETAILS PRESET: • Analog Overdriv
Page 53 and 54: PRESET BACKUP Vous pouvez sauvegard
Page 55 and 56: F0 00 00 1B 11 00 0E 01 06 01 01 07
Page 57 and 58: GLOBALS Offset Name Range (Decimal)
Page 59 and 60: DEUTSCH BAM 210 BASS-MODELING-VERS
Page 61 and 62: möglichem Clipping gewarnt. Leucht
Page 63 and 64: PEAVEY MAX BAM 2 X 10 Hybrid-Bass-V
Page 65 and 66: (24) ERDUNGSPOLARITÄT Dieser Wippe
Page 67 and 68: ein F gespielt, wird es als solches
Page 69 and 70: TUNER-MODUS Der Tuner-Modus wird du
Page 71 and 72:
TUNER: • Store Tuner Tweaks - Das
Page 73 and 74:
HINWEIS: Main Volume befindet sich
Page 75 and 76:
Zum Einstellen des Bits für Kompre
Page 77 and 78:
GLOBALS Offset Name Range (Decimal)
Page 79 and 80:
PEAVEY ELECTRONICS CORPORATION LIMI
show all

BAM 210 Operation Manual - Peavey.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?