Industrial shaft seals

gab.ru Берг АБ bergab@ya.ru Тел. (495)-228-06-21,
Industrial
факс
shaft seals
(495) 22
Industrial shaft seal designs
The seals shown in this catalogue are intended
for the sealing of openings between a rotating
and a stationary component or between two
components in relative motion. The tasks of
the seals are
N to retain lubricant,
N to exclude contaminants,
N to separate fluids or gases, and
N to withstand differences in pressure.
The seals should also perform adequately with
a minimum of friction and wear even in critical
applications or under unfavourable operating
conditions.
In order to meet these different requirements,
SKF shaft seals for rotating machine
components are produced in many designs,
materials and executions. Each of these
designs and their material combinations has
specific properties which make it more, or less,
suitable for a particular application. The main
groups are:
Radial shaft seals
N Small diameter seals (SDS, for shaft
diameters up to 200 mm / 8 inch),
N Large diameter seals (LDS, for shaft
diameters over 200 mm / 8 inch),
N Radial shaft seals, PTFE material.
Axial shaft seals
N Mechanical seals,
N V-ring seals,
N Axial clamp seals.
Wear sleeves are also manufactured as special
accessories.
The inclusion of a single design to the SKF
range of seals is not an indication of its availability;
this should always be checked before
ordering. The products shown in the size listing
tables in this catalogue are the more popular
metric and inch sizes. Information about the
complete range will be found in our standard
range stock list, which can be supplied on
request.
gab.ru Берг АБ bergab@ya.ru Тел. (495)-228-06-21, факс (495) 9 22