Industrial shaft seals

gab.ru
Radial
Берг
shaftАБ sealsbergab@ya.ru Тел. (495)-228-06-21, факс (495) 22
Series CRW1
CRW1
CRWH1
CRWA1: Seal with single steel shell, Bore-Tite
coated outside diameter, hydrodynamically
formed Waveseal lip, carbon steel garter spring
and non-rubbing secondary lip.
CRWHA1: Seal with double steel shell, Bore-
Tite coated outside diameter, hydrodynamically
formed Waveseal lip, carbon steel garter spring
and non-rubbing secondary lip.
CRWA1
CRWHA1
Features
SKF CRW1 radial shaft seals are low friction
seals with Waveseal lip design for reduced heat
generation and steel shell for easy installation
and a firm and accurate seating in the housing
bore. CRW1 seals are coated on the outside
diameter with Bore-Tite, a non-hardening,
water-based polyacrylate sealant, which helps
to fill out small imperfections in the housing
bore.
Primarily for lubricant retention but seals of
CRWA1 and CRWHA1 designs are also suitable
for exclusion of dust and light contamination.
Further information about material, application
and operating conditions for SKF CRW1 seals
is shown in the seal selection chart on page
98.
CRW1: Seal with single steel shell, Bore-Tite
coated outside diameter, hydrodynamically
formed Waveseal lip and carbon steel garter
spring.
CRWH1: Seal with double steel shell, Bore-Tite
coated outside diameter, hydrodynamically
formed Waveseal lip and carbon steel garter
spring.
gab.ru 114Берг АБ bergab@ya.ru Тел. (495)-228-06-21, факс (495) 22