Industrial shaft seals

gab.ru Берг АБ bergab@ya.ru Тел. (495)-228-06-21,
Industrial
факс
shaft seals
(495) 22
All-rubber seals series HS
Type HS seals, available in solid round and split
designs, are all-rubber, large diameter seals
designed without an outer shell or metal case.
HS solid and split large diameter seals are
cataloged by shaft size and priced by the
dimensions of the bore for which they are
designed. The actual seal outside diameter is
approximately 0,5 % to 2 % larger than the seal
housing bore. Actual seal width is approximately
0,4 to 0,8 mm (0.016 to 0.031 in)
wider than the bore depth. A cover plate is
required to compress the seal within the cavity,
helping seal the split joint and prevent leakage.
A garter-type spring embedded in the
sealing element reinforces lip pressure against
the shaft.
The HS solid and split seal product line is
available in sizes ranging from 203 to
4 572 mm (8 to 180 in) (Table 22 on page
213).
HS solid seal types
HS solid seals can be made as standard types
from 203 mm (8 in) up to unlimited shaft size.
There are two types:
HS4
HS5
HS4
HS4 seal is an all-rubber solid seal with a
single spring-loaded element. It features a
Spring-Lock (page 20) and is recommended
for vertical and horizontal shafts. For proper
fit, a cover plate is required.
HS5
HS5 is the same as HS4 with the addition of a
Spring-Kover (page 20) for added protection
against spring pop-out and contamination.
gab.ru Берг АБ bergab@ya.ru Тел. (495)-228-06-21, факс 207 (495) 22