Industrial shaft seals

gab.ru
Wear
Берг
sleeves
АБ bergab@ya.ru Тел. (495)-228-06-21, факс (495) 22
Fig 78
Fig 79
Speedi-Sleeve ®
Speedi-Sleeves are made of stainless steel and
have a wall thickness of 0,254 mm (0,01 inch).
Because of the extreme thinness, the diameter
of the seal seating will only be increased by
about 0,5 mm so that it is possible to use
replacement seals of the same size as the
original.
The sleeves have a hardness of 95 HRB and
a surface roughness of between 0,25 to 0,5 R a
µm. Thus they often offer a better counter face
for the seal lip than the original shaft itself.
Normally, Speedi-Sleeves can be mounted
immediately on the cleaned shaft (fig 78,
fig 79 and fig 80. Only in cases where the
shaft exhibits deep grooving or is otherwise
damaged is it advisable to first apply powdered
metal epoxy filler to the grooves and other
damaged areas.
All SKF Speedi-Sleeves have a removable
installation flange at one side for easy
mounting together with the mounting tool
supplied with each sleeve. The flange can be
retained to act as a flinger or can be removed
easily as a pre-cut tear groove is provided.
Fig 80
gab.ru 282Берг АБ bergab@ya.ru Тел. (495)-228-06-21, факс (495) 22