Industrial shaft seals

gab.ru Берг АБ bergab@ya.ru Тел. (495)-228-06-21,
Industrial
факс
shaft seals
(495) 22
Series CRW5
CRW5
CRWA5
Features
Radial shaft seals for applications where
pressure differential across the seal is
moderate. Waveseal lip for reduced heat
generation and steel shell for easy installation
and a firm and accurate seating in the housing
bore.
Primarily for lubricant retention, but the
CRWA5 design will also exclude dust and light
contamination. Where there is a pressure
differential across the seal, the seal should be
axially secured in the housing bore.
CRW5: Seal with steel shell, Bore-Tite coated
outside diameter, hydrodynamically formed
Waveseal lip and carbon steel garter spring.
CRWA5: Seal with steel shell, Bore-Tite coated
outside diameter, hydrodynamically formed
Waveseal lip, carbon steel garter spring and
non-rubbing secondary lip.
Series CRW5 is only available in a limited
range of inch sizes.
Further information about material, application
and operating conditions for SKF CRW5 and
CRWA5 seals is shown in the seal selection
chart on page 98.
gab.ru Берг АБ bergab@ya.ru Тел. (495)-228-06-21, факс 173 (495) 22