Industrial shaft seals

gab.ru
Radial
Берг
shaftАБ sealsbergab@ya.ru Тел. (495)-228-06-21, факс (495) 22
Series CRS
CRS1
CRSA1
CRSH1
CRSHA1
CRS1, CRSH1, CRSA1, CRSHA1: Radial shaft
seals of high stiffness particularly for difficult
or rough installation and operating conditions.
Limited static sealing between outside
diameter and housing bore.
CRS1: Seal with single steel shell, conventional
sealing lip and carbon steel garter spring.
CRSA1: Seal with single steel shell,
conventional sealing lip, carbon steel garter
spring and a secondary, contacting (dust) lip.
CRSH1: Seal with double steel shell,
conventional sealing lip and carbon steel garter
spring.
CRSHA1: Seal with double steel shell,
conventional sealing lip, carbon steel garter
spring and secondary, contacting (dust) lip.
Radial shaft seals of CRS design are stocked in
a wide range of sizes. They are available in lip
material R (NBR) for general purpose and in lip
material V (FPM) for higher operating
temperature and for extended chemical
resistance.
Further information about material, application
and operating conditions for CRS seals is
shown in the seal selection chart on page 98.
gab.ru 184Берг АБ bergab@ya.ru Тел. (495)-228-06-21, факс (495) 22