Texas Instruments TI-34 MultiView? Scientific ... - Radio Shack
Texas Instruments TI-34 MultiView? Scientific ... - Radio Shack
Texas Instruments TI-34 MultiView? Scientific ... - Radio Shack
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Battery information<br />
E<br />
Battery<br />
precautions<br />
Battery<br />
disposal<br />
Remove or<br />
replace the<br />
battery<br />
Type of battery<br />
• Do not leave batteries within the reach of children.<br />
• Do not mix new and used batteries. Do not mix brands (or types<br />
within brands) of batteries.<br />
• Do not mix rechargeable and non-rechargeable batteries.<br />
• Install batteries according to polarity (+ and -) diagrams.<br />
• Do not place non-rechargeable batteries in a battery recharger.<br />
• Properly dispose of used batteries immediately.<br />
• Do not incinerate of dismantle batteries.<br />
• Seek medical advice immediately if a cell or battery has been<br />
swallowed. (In the USA, contact the National Capital Poison<br />
Center at 1-800-222-1222.)<br />
Do not mutilate, puncture, or dispose of batteries in fire. The batteries<br />
can burst or explode, releasing hazardous chemicals. Discard used<br />
batteries according to local regulations.<br />
Per CA Regulation 22 CCR 67384.4, the following applies to the button<br />
cell battery in this unit:<br />
Perchlorate Material - Special handling may apply.<br />
See www.dtsc.ca.gov/hazardouswaste/perchlorate<br />
Remove the protective cover and turn the <strong>TI</strong>-<strong>34</strong> <strong>MultiView</strong> face downwards.<br />
• With a small screwdriver, remove the screws from the back of the<br />
case.<br />
• From the bottom, carefully separate the front from the back. BE<br />
CAREFUL not to damage any of the internal parts.<br />
• With a small screwdriver (if required), remove the battery.<br />
• To replace the battery, check the polarity (+ and -) and slide in a<br />
new battery. Press firmly to snap the new battery into place.<br />
Important: When replacing the battery, avoid any contact with<br />
the other components of the <strong>TI</strong>-<strong>34</strong> <strong>MultiView</strong>.<br />
• Dispose of the dead batteries immediately and in accordance<br />
with local regulations.<br />
The <strong>TI</strong>-<strong>34</strong> <strong>MultiView</strong> uses one 3 volt CR2032 lithium battery.<br />
© 2007 TEXAS INSTRUMENTS INCORPORATED <strong>TI</strong>-<strong>34</strong> <strong>MultiView</strong>: A Guide For Teachers E-1