AT-3624TR/3648TR Installation Manual - Allied Telesis

Hardware Installation
4. Slide the replacement appliqué into the port cavity so its faceplate is
flush with the surface of the hub faceplate. Then, screw it down with
the two thumb screws provided with the replacement appliqué, as
shown in Figures 15. Do not overtighten.
Thumb
screws
Front
Appliqué
Figure 15: Module Faceplate
Interface
Back
To remove a 10BASE2, 10BASE-T or fiber Optic (10BASE-FL)
appliqué
1. Loosen the two thumb screws (shown in Figure 15) and pull out the
existing appliqué.
2. Remove the 4-40 pan-head screws from the AUI connector and ribbon
cable assembly (reverse of Step 3 and related Figure 14 above).
3. Store the removed 10BASE2, 10BASE-T, or 10BASE-FL appliqué
assembly in a secure container for future use.
To install an AUI appliqué
1. Using the supplied screws, washers, and nuts, attach the AUI appliqué
connector plate and locking bracket (slide-kit) to the AUI connector.
(Reverse order of Steps 1 through 5 and associated Figure 10 through
Figure 12 above.)
2. Using the two M3x6 flat-head appliqué screws, attach the AUI
appliqué to the hub faceplate.
Attention
Loose metal parts can cause damage to exposed circuit boards and
components. Handle parts and any required tools with care during
installation.
16