AT-3624TR/3648TR Installation Manual - Allied Telesis
AT-3624TR/3648TR Installation Manual - Allied Telesis
AT-3624TR/3648TR Installation Manual - Allied Telesis
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
CentreCOM 3600 Series Hub/Repeaters<br />
Port Status Indicators<br />
The port indicators on the <strong>AT</strong>-3600 Series hub front panels provide visual<br />
diagnostic and activity information for network analysis.<br />
The <strong>AT</strong>-3612T has a central bank of indicators, as shown in Figure 37.<br />
PORT ST<strong>AT</strong>US<br />
No Link OFF<br />
Link Green ON<br />
Receiving Green FLASHING<br />
1 3<br />
PORT ACTIVITY<br />
INDIC<strong>AT</strong>OR ST<strong>AT</strong>US<br />
5 7<br />
Partitioned<br />
Collision<br />
Amber ON<br />
Amber FLASHING<br />
9 11<br />
2 4<br />
6 8<br />
10 12<br />
Figure 37: <strong>AT</strong>-3612T Port LEDs<br />
Each 10BASE-T port supports the following indicator functions with one<br />
dual-color front panel LED per port. Note that the LEDs do not reflect<br />
real-time activity because a data packet is too fast for the human eye to<br />
distinguish on the LED indicator; therefore, the hub artificially stretches<br />
the LED ON time for easier observation.<br />
LINK (Steady Green)—This indicates that the particular port has a valid<br />
link and is not partitioned.<br />
RECEIVING (Flashing Green)—When a port’s LED is blinking, the port<br />
is receiving Ethernet packets.<br />
PARTITIONED (Steady Amber)—A steady amber port indicator means<br />
the port is partitioned or segmented from the rest of the ports. This<br />
partitioning may be associated with a management function or with an<br />
error condition on the link.<br />
COLLISION (Flashing Amber)—A momentary amber flash occurs when<br />
a collision is detected on the port.<br />
NO LINK (No Light)—If the Link Test function is not met by the<br />
10BASE-T device at the opposite end of the UTP segment, this LED will<br />
not illuminate. This may occur if the workstation at the end of the<br />
segment is turned off or if the UTP segment is disrupted or damaged.<br />
37