CME136686LX Hardware Manual - RTD Embedded Technologies ...

– Easy to Use
• Low Power Features
• LED Status
• Software configuration
• VGA controller
– Analog SVGA Output
– LVDS Flat Panel output
– Resolution up to 1920 x 1440 pixels
– VGA, SVGA, XGA, XGA+, SXGA, and UXGA
– Up to 4,294 million colors
– 24MB of shared DDR SDRAM high-performance memory
• Software-configurable RS-232/422/485 serial ports
– 16550 compatible UARTs for high-speed
– Termination resistors for RS-422/485
– Each serial port connector can be configured as two limited serial ports, for a total of four serial
ports
• multiPort function connector
– Parallel port
• SPP, PS/2 bi-directional, EPP & ECP
– Advanced Digital I/O (aDIO)
• One 8-bit port programmable as input or output
• Eight bit-programmable I/O with Advanced Digital Interrupt Modes
• Event Mode Interrupt generates an interrupt when any input bit changes
• Match Mode Interrupt generates an interrupt when input bits match a preset value
• External Strobe Mode latches 8 data inputs and generates and interrupt
• Two Strobes can be configured as readable inputs
– Floppy controller interface
• Interfaces with RTD's multiPort Floppy Drive and Cable Kit
– ESD protection
• Two USB 2.0 (Universal Serial Bus) Ports
– Supports 480 Mb/s (high-speed), 12Mb/s (full-speed), and 1.5Mbs (low speed) peripherals
– 500 mA @ 5 Vdc provided per port
– USB Boot capability
– USB keyboard, mouse, and disk support for legacy OSes (e.g. ROM-DOS)
• UltraDMA-100 / 66 / 33 Master Mode PCI EIDE Controller
– Single Channel
– Transfer rate up to 100MB/sec using UltraDMA
– Increased reliability using UltraDMA-33 transfer protocols
– Support ATAPI compliant devices including DVD drives
– 48-bit LBA support for hard drives larger than 137GB up to 2.2 terabytes
• 32 pin ATA/IDE Disk Chip Socket
– Miniature ATA/IDE Flash Disk Chip
BDM-610000065 Rev C Chapter 1: Introduction 15