CME136686LX Hardware Manual - RTD Embedded Technologies ...

Main Menu Setup Fields
The following is a list of Main Menu Setup fields.
Table 37
Main Menu Setup Fields
Field Active Keys Selections
Main Press Enter to select Access system information such as BIOS version, EPLD
version, and CMOS time and date settings
Advanced Press Enter to select Setup advanced cpuModule features
PCIPnP Press Enter to select Set PnP and PCI options and control system resources
Boot Press Enter to select Set the system boot sequence
Security Press Enter to select Setup the supervisor and user access passwords or
enable boot sector virus protection
Power Press Enter to select Control power management settings, including power
supply type, and system wake functions
Health Press Enter to select Monitor the cpuModule temperature
Exit Press Enter to select Save or discard changes and exit the BIOS, or load the
default BIOS settings
Note Future BIOS versions may have slightly different setup menus and options.
Power On Self Test (POST) Codes
Each POST Code represents a series of events that take place in a system during the POST. If the POST fails during
a particular POST Code, the system will not boot as expected.
The BIOS uses I/O port 80h to store the active POST Code. A POST Code board is a tool that is used to display
the POST Codes on I/O port 80h. This is usually accomplished with two 7-segment LEDs. Such a board is useful
for debugging a system that is unable to boot.
BDM-610000065 Rev C Chapter 4: Using the cpuModule 59