Nanosurf easyScan 2 AFM Operating Instructions

CHAPTER 1: THE EASYSCAN 2 AFM
– Blinking red
There is no laser signal with which to do feedback: see Section 9.3.1: Probe Status light
blinks red (page 91) for possible causes and for more information on how to resolve this
situation).
The Scan Head lights
Indicate the Scan Head type that is connected to the instrument. The Scan Head lights blink
when no Scan Head can be detected, or when the controller has not been initialized yet.
The Module lights
Indicate the modules that are built in into the controller. The module lights blink when the
controller has not been initialized yet. During initialization, the module lights are turned on
one after the other.
The Video Out connector
An RCA/cinch connector that outputs a PAL video signal that can be connected to a video
monitor.
18