DeNight Special 50 Manual - CMC Versand

Step 4
Use a ruler to locate the center of the opening in the
aileron hatch and make a mark with a felt-tipped pen.
Step 6
Use a pencil to mark the location of the servo on the
inside of the aileron hatch.
Step 8
Place the servo between the mounting blocks and
space it 1/32 inch from the hatch. Use a pencil to mark
the mounting hole locations on the blocks.
Step 5
Align the aileron servo arm with the mark and center it
within the width of the cutout.
Note: You may find a different hatch configuration on
your model than shown. Use the same technique to
align and install the servo.
Step 7
Mix some 30-minute epoxy and use it to glue the
servo mounting blocks in place on the hatch. Space
the blocks 1/32 inch from the lines marking the servo
case to allow for the flanges on the rubber grommets.
Step 9
Use a 1/16-inch drill bit in a pin vise to drill the
mounting holes in the blocks.
16 DeNight Special 50 ARF Assembly Manual