DeNight Special 50 Manual - CMC Versand

Step 6
Slide the spinner backplate and propeller onto the
propeller shaft. Locate the propeller blades midway
between the small pin and hole in the backplate.
Step 8
Press the spinner cone into place by engaging its
alignment pins into the holes in the backplate. Check
that the cutouts in the spinner cone are clear of the
propeller blades then use a #1 Phillips screwdriver to
secure the spinner with two #4 x 1/2-inch screws.
Battery and Battery Tray Installation
Parts Required
Fuselage
Battery tray with spacers
Battery
Hook and loop strap
#4 steel washer 4-40 x 1/2-inch Allen screw
Tools required
3/32-inch hex wrench Medium CA
Hobby knife with #11 blade
Step 7
Install the propeller nut and use the shaft of a hex
wrench or screwdriver to tighten it in place.
Step 1
Align the hole in the square spacer with the hole in the
rear end of the battery tray and glue it in place with
medium CA.
22 DeNight Special 50 ARF Assembly Manual